circa LIGHTING TOB 5739 Fitz XL Pendant Instruction Manual

: June 5, 2024
: circa LIGHTING

Table of Contents

ASSEMBLY INSTRUCTIONS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TOB 5739 Fitz XL Pendant
Instruction Manual

ASSEMBLY INSTRUCTIONS

circa LIGHTING TOB 5739 Fitz XL Pendant - fig 1

Fitz XL Pendant
Item # TOB 5739
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. TOOLS REQUIRED (NOT INCLUDED):

Phillips Screwdriver
Slotted Screwdriver
Wire Cutters
Wire Strippers

Carefully remove all parts from the box. Place on a clean, soft surface.
Remove mounting plate (B) from the canopy (F) by removing the collar ring (G).
Install mounting plate (B) to the junction box and secure with mounting screws (C).
Feed electrical and ground wires through bottom rod (J) and connect to fixture (K). Repeat for middle rod (I), connecting to bottom rod (J).
Continue feeding wires through collar ring (G) and canopy (F).
Holding fixture upright, slide collar ring (G) and canopy (F) down and rest on fixture (K). Then connect top rod (H) to middle rod (I).
NOTE: Slide components down slowly to avoid damages.
Hang fixture swivel ball (O) to the center of mounting plate (B) and secure set screw (Q) using provided wrench (P).
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded.
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections.
Make sure all wire connections are tight, then carefully tuck into the junction box.
Install canopy (F) to mounting plate (B) and secure with collar ring (G).
Install light bulb into the socket.
Install glass shade (D) to bracket (M) and secure by bending metal taps (E).
. Remove threaded caps (N) from screws (L), then install metal shade bracket (M) to bottom of fixture (K) and secure with screws (L) using threaded caps (N).