HAMRON 004158 Bike Carrier Instruction Manual
- June 5, 2024
- HAMRON
Table of Contents
HAMRON 004158 Bike Carrier
OPERATING INSTRUCTIONS
Important! Read the user instructions carefully before use. Save them for future reference. (Translation of the original instructions).
Jula reserves the right to make changes.
For latest version of operating instructions, see
www.jula.com
SAFETY INSTRUCTIONS
- Read these instructions and safety instructions carefully before assembly and use. The manufacturer cannot accept liability for personal injury or material damage resulting from failure to follow the instructions.
- Be careful when driving through underpass, tunnel, car park, and garage etc.
- After driving a short distance double-check that all screw unions and other connections are tight, and retighten if necessary. Re-check at regular intervals during the trip. Replace straps and screw unions immediately if they are worn or damaged.
- Braking and accelerate smoothly.
- Avoid sharp swerves. Do not turn at speeds over 40 km/h.
- Do not drive at speeds over 40 km/h in heavy traffic.
- Do not exceed speed limits. Never drive faster than 120 km/h with a bike on the bike carrier.
- Before starting and after driving a short distance, doublecheck that all screw unions and other connections are tight, and that the product is in good condition. Retighten, if necessary. Re-check at regular intervals during the trip.
- Do not cover bikes with material that can get blown away.
- Clean the product with a damp cloth or alcohol after use. Lubricate all screw unions with a suitable oil and store the product in a dry place. Remove the bike carrier before washing the car. Do not expose the product to solvents or caustic solutions.
DESCRIPTION
Component parts on bike carrier.
FIG.1
ASSEMBLY
The bike carrier can be assembled in two different ways:
With the U-fasteners round a square profile
FIG.2
On roof rack with T-slot.
FIG.3
Start by opening the wheel straps on the wheel stops and putting the bike on the carrier as shown. Lock the bike frame by following steps 1-5.
FIG.4
Adjust if necessary the distance to the frame on the actual bike.
FIG.5
Adjust if necessary the distance between the wheel stops.
FIG.6
Tighten the wheel straps.
FIG.7
Remove all spanners etc. when the bike is secured.
FIG.8
Documents / Resources
|
HAMRON 004158 Bike
Carrier
[pdf] Instruction Manual
004158 Bike Carrier, 004158, Bike Carrier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>