PHOENIX GOLD Z110AB-V2 Active Subwoofer Enclosures User Manual

June 3, 2024
PHOENIX GOLD

phoenix gold logo

PHOENIX GOLD Z110AB-V2 Active Subwoofer Enclosures

PHOENIX GOLD Z110AB-V2 Active Subwoofer Enclosures

SPECIFICATION

SPECIFICATION Z110AB-V2 Z112AB-V2
Peak Power (Watts) 320 Watts 320 Watts
Max Power (Watts) 160 Watts 160 Watts
RMS Power (Watts) 80 Watts 80 Watts
Amplifier Type Class-AB Class-AB
 re uency Response 10Hz-200Hz 10Hz-200Hz
Signal to noise ratio >60dB >60dB
Crossover Slope 6dB per octave 6dB per octave
Crossover Range 50Hz – 200Hz 50Hz-200Hz
Tuning Bass Reflex Bass Reflex
Woofer Size 10” 12”
Fuse 15A 15A
Dimensions (mm) 476(w) x 343(h) x 331(d) 560(w) x 384(h) x 394(d)

Disclaimer

Always ensure the Active Enclosure is securely attached, to avoid movement. PHOENIX GOLD accepts no responsibility for damage or injury in relation to inappropriate securing of this product.

Control Descriptions

LEVEL
This allows the adjustment of the amplifier level of the sub woofer. Turn clockwise to increase the level. If the sound becomes distorted reduce the level.

LOW PASS FILTER (LPF)

This allows the adjustment of the highest frequency the Active Enclosure will produce. This should be adjusted to blend with your main speakers. Typically, this will be set
to around 100Hz (approximately the central position of the control knob)

BASS REMOTE CONTROLLER

This control can be mounted in the front of the vehicle to give you control of your subwoofers output level.

Installation

Make sure the Active Enclosure is firmly fixed in your ve hicle. Check before drilling or cutting holes. DO NOT work near fuel tanks, fuel lines hydraulic lines or electrical wiring. DO NOT mount the Active Enclosure in such a way as to pinch or damage the wires. Make sure everything is firmly connected before attaching a +12V wire. Ensure the +12V wire is fused as close as possible to the battery. Always use a fuse with the recommended rating.

Wiring

  • Connect the ground wire to the vehicle first (clean dirt and paint to bare metal)
  • Connect the remote on (blue wire)
  • Connect the RCA cables if applicable OR
  • Connect the speaker level wire by splicing into the headunits speaker wires. See Note1 on adjacent page.
  • Connect the remote level controller with the supplied lead
  • Please ensure power wire is fused within 12″ of battery
  • Connect the 12 volt (red wire) to the positive battery terminal.
  • Check all connections.

PHOENIX GOLD Z110AB-V2 Active Subwoofer Enclosures 1

Phoenix Gold is a division of AAMP Global 15500 Lightwave Drive Suite 202, Clearwater FE33760
info@phoenixgold.com
www.phoenixgold.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

PHOENIX GOLD User Manuals

Related Manuals