PHOENIX GOLD ZDAPV1 Volvo DSP Power Up Kit Instructions
- October 30, 2023
- PHOENIX GOLD
Table of Contents
ZD series
INTEGRATION
ZDAPV1 Volvo DSP Power Up Kit
Thank you for buying this upgrade kit. We think you will love this product and
we hope that you will enjoy the extra performance this will give you!
Installation should take about 10min please mount amplifier as you see fit but
we recommend it to be mounted in back of the car. No cutting off any wires just
plug connectors in and load the software and you are good to GO!
PS. If you wish to give the optimal performance to the amplifier you can
connect thicker cables on the +12V and GND connectors for the amp. From the
battery. This will improve performance further.
| Step by step Instruction| Notes
---|---|---
1| Connect multiconnector to amplifier & Connect the Yellow wire to +12 Volt
and black cable to GND| 20-way black connector
2| Connect the ISO connector together firmly| These terminal can also be
connected to
battery and ground for better performance
3| Locate the Original amplifier under right from seat and disconnect the
Original wires from the amplifier and
connect the leads from the amp to the amplifier and the other end to the
original connector|
4| Now start the system and upload the preferred Volvo setup file from Phoenix
gold EU Website| https://phoenixgold-eu.com/downloads/
INSTALLATION MANUAL ZDAPV1
Documents / Resources
|
PHOENIX GOLD ZDAPV1 Volvo DSP Power Up
Kit
[pdf] Instructions
ZDAPV1, ZDAPV1 Volvo DSP Power Up Kit, Volvo DSP Power Up Kit, Power Up Kit
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>