PHOENIX GOLD ZDAPB1 BMW DSP Power Up Kit Instruction Manual
- June 10, 2024
- PHOENIX GOLD
Table of Contents
PHOENIX GOLD ZDAPB1 BMW DSP Power Up Kit Instruction Manual
BMW 3-Series (E90/E91/E92/E93
- 2005 – 2012
- E90/E91/E92/E93
- Basic Sound System
- Before installing check placement of the amplifier. If the amplifier is to be installed in the trunk a separate 5m cable i required.
- If it is to be installed under the passenger seat, check that there is room.
Stereo Removal
-
Use a plastic pry tool on the outer edge of the plastic panel to pop it out.
-
The panel is now loose. Either unplug the connectors on the back of the panel or put it to the side.
Tools required:
-
PH2 Screwdriver
-
Loosen the two screws marked with red circles. Then the stereo is loose and ready to be taken out.
-
Remove the quadlock connector and the fakra connector from the stereo.
Cable Installation
-
OBS! If there is a fiber optic cable in the original quadlock connector (the green wire and the green wire with black wire loom om) then that cable needs to be transfered to the new quadlock connector.
-
If there is no such cable skip to Cable installation 3.
-
Under the fiber optical cable theis a little lock. Use a small flat screwdriver or something tiny to loosen the connector.
-
Connect the T-ISO harness.
-
Connect the fiber optical cable to the new quadlock connector.
-
If you do not have a fiber optical cable skip to the next step.
-
Connect the ISO connectors to the ZDAISOT cable harness.
-
Take the ZDAISOT cable and run it behind the inner plastic panel behind the stereo.
Tools required:
- Remove the panel under the glovebox by removing the two screws.
- Pull out the cable between the panels.
- Continue to pull the cable either to under the passanger seat or the the trunk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>