Hamron 016038 Light Bar LED Instruction Manual
- June 5, 2024
- HAMRON
Table of Contents
Hamron 016038 Light Bar LED Instruction Manual
SAFETY INSTRUCTIONS
- Read these instructions carefully before installation and save them for future reference.
- Always comply with the applicable laws and regulations for the installation and use of auxiliary headlights.
SYMBOLS
Read the instructions.
Approved in accordance with the relevant directives.
TECHNICAL DATA
- Rated voltage: 9 — 36 VDC
- Light source: 24x5WLED
- Output: 120 W
- Luminous flux: 10800 Im
- Colour temperature: 6000 K
- Range: 1 lux at 388 m
- Range: 0.25 lux at 776 m
- Protection rating: IP68
- Cord length: 50 cm
- E-approved: Yes
- ETM*: Yes
- Size: W360 x H58.5 x D52.5 mm
- Weight : 1.53 kg
Electronic thermal management
DESCRIPTION
Powerful extra lighting that makes driving safer and less tiring. Hamron’s powerful light bar has double rows of ultra bright LED light sources. This produces a wider and more powerful beam. There are a total of 24 x 5 W LED light sources that deliver 10800 theoretical lumen and 9180 actual lumen. The beam is a so-called Combo beam, which means that the light bar produces a beam a long way ahead on the road, while diffuse reflectors on the sides create a wide and uniform beam to provide light on the sides of the road. LED light sources have electronic thermal monitoring (ETM), which retains the
intensity of the diodes and avoids discolouring if the heat becomes excessive. Adapted for fixed installation and mounted on the supplied side fasteners made of stainless steel. Installation accessories and DT connector included.
FIG. 1
ETM
Thanks to Electronic Thermal Management (ETM) the intensity of the diodes is maintained and discolouring is avoided if the heat becomes excessive.
INSTALLATION
- Disconnect the negative/chassis earth cable from the battery before connecting the product, to avoid damage from short-circuiting during the installation.
- Follow as far as possible the existing cable routing for installation of new cables. Carefully fasten the cable and any excess length with cable ties, insulating tape or the equivalent. Cable grommets through the firewall should be at a safe distance from moving parts.
- Drill screw holes with a diameter of 8.5 mm in the surface where the product is to be installed.
- The product can be mounted with side (1) or bottom (2) fasteners. Put the screws in the holes, put on the lock washers and tighten the nuts.
FIG. 2
Cable colour coding
The DT connector’s red wire is (+) and the black wire is (-)
Warning
- The product must only be used within its rated voltage range, 9 to 36 VDC.
- The light source gets hot when the product is switched on. Allow the light source to cool for at least 30 minutes before touching or handling it.
- Make sure there is a free flow of air through the cooling fins on the light source and keep the fins clean.