MARIMEX 10992043 Sunny Style Solar Shower Instruction Manual
- June 5, 2024
- MARIMEX
Table of Contents
MARIMEX 10992043 Sunny Style Solar Shower
introduction
- DO NOT Eat outside during cold months (keep safe from frost)
- During the transport of the shower do not hold the pipe, but lift the tank (possibly disassembling the top side of the pipe).
- ATTENTION: potential high working temperature. It can reach up 60°C/140°F
- DO NOT let kids operate the shower.
- WARNING: a light dripping just next to the safety valve has been accepted, in order to assure a long-lasting life of the article.
- DO NOT step on the tank.
- DO NOT seat on the tank.
- DO NOT hang or sway by the shower pipe.
- DO NOT remove the pressure-reducing valve and safety valve.
- After use, always switch off the main power source (water inlet tap).
- It is advised that you install a filter upstream of the tank in order to remove any impurities from the water.
- The indicated temperatures are only theoretical, they depend on weather conditions.
CARE AND MAINTENANCE
To optimize performance, dean the transparent cover periodically using aggressive products and non-ag
DISPOSAL
dismantle the product and dispose of individual components separately
(plastics and metals).
This shower system is suitable for any external area and uses natural solar
energy, thus is capable of providing free hot water.
Sunny uses the energy from the sun’s rays to0 produce hot water ecologically
and without using any electricity. Just like a solar panel, the storage tank-
base of the shower is connected to the water network and is exposed to the sun
for about2 hours, it heats the water therein to over 60°C/140°E, This water
appropriately combined with cold water
through the mixer, enables a hot water supply at approximately 30°C/86°E.
Therefore, the showering system can provide I/8 consecutive shower sessions of
about two minutes each, however, if there is a few minutes in between each
session, then basically the system could provide an infinite number of showers
during the whole day. The pressure
The control valve placed on the base of the unit provides total safety and
comfort even to small children.
ASSEMBLY
Angle the tank sideways (setting it against one of its 3 plastic feet) and
screw tight the ringed union elbow to the protruding thread of the black pole
until it is completely fastened (the elbow union is free to turn).
UTILIZATION
- Note: when filling the tank, switch the mixer knob to hot water until the air is completely expelled (you Will notice a uniform water flow), Ihen switch the knob to stop. Wait for the water to warm up.
- Note: Before use, switch the mIxer to cold water. then gradually turn the know up to the desired temperature.
- Note: After first usage and periodically, check that no impurities are in the drilled plate by opening the shower ring.
- Note: Before assembling the set, check the presence of the pressure reduction valve (A) and safety valve (B).
- Periodically check that the safety valve is operating properly by gently pulling and releasing the knob in order to prevent scale sedimentation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>