TECHKO SGL-401 Solar Garden Light User Manual
- June 17, 2024
- TECHKO
Table of Contents
TECHKO SGL-401 Solar Garden Light
PRODUCT SPECIFICATION
| Material | ABS | Solar Panel | 3.1 x3.1 inch / 1.5 W |
|---|---|---|---|
| Battery | Li-ion battery 18650 2200mAh | Waterproof Performance | IP65 |
| Sile | 4.48 x 29.92 inch | Accessories | 1*Ughting section |
1Low section
1Ground spike
1*User man Jal
This product has a 1-year called \ warranty. For father Information piesevisit
our website at www.techkogroup.com Copyright
Reeved
Patent Pending: US 16/279. 107; CN201920118689.6
▲ Please carefully read this manual before using the product
▲ Keep the manual widl1 you folr reference as needed.
PLEASE FULLY CHARGElHE PRODUCT BEFORE USING1
- Secure the unit and fully charge in direct sunlight and select desired operating mode (flame or still) before u se.
- Charging time may vary depending on the weather, temperature and seasons.
- Do not place the product indoors or any place where there is no direct sunlight, the product will not charge properly.
- Keep the solar panel clean to ensure the product can be properly charge d. Frequently clean t he solar panel as needed. Avoid scratching on the panel or it may lower charging efficiency.
INSTALLATION INSTRUCTIONS
-
Pull the ground spike out from inside the lower sect ion.
-
Careft1lly ,insert t he g round spike into tile lower section mat chi ng the notches together.
-
Carefully insert the lighting section into the lower section matching the notches together.
-
Position the ground spike and press firmly to secure the solar garden light into t he ground,
▲ Please install the unit in a place where the solar panel can be panel is
equipped with daylight sensor. The product will charge continually exposed to
the sun.
▲ Avoid placing the unit where shade from buildings or objects would block the
solar panel.
▲ The switch is on the top of the solar unit.
▲ The product can be charged in all operating modes. The solar in direct
sunlight during the daytime and automatically turn on at dusk
SWITCH & FUNCTIONS
(Please see Figura A for reference)
- Flame Mode: Slide switch to the “Flame ” position. The light will II um in ale with a flicker[ ng flame effect.
- Still Mode: Slide switch to “Still” position, the light will stay illuminated. Please note all LED ‘s will not be illumi1nated in this setting.
- Off Mode: Slide switch to the ‘Off” position, the light power is off.
WARNING & NOTICE
- Do not look directly at the LED light, or it may damage your eyes。
- Do not attempt to disassemble or remodel the product。 Any changes can be dangerous and will void the warranty.
- Pease keep the product away from the flammable items, or explosion or casual injuries may occur。
- Please switch OFF the product when it is not in use for a long period of time.
