Nedis HTPA20EBK Terrace Heater User Manual

: June 5, 2024
: nedis

HTPA20EBK Terrace Heater

Nedis HTPA20EBK Terrace Heater

User Manual

Preface

Thank you for purchasing the Nedis HTPA20EBK.

This document is the user manual and contains all the information for correct, efficient and safe use of the product.

This user manual is addressed to the end user. Read this information carefully before installing or using the product.

Always store this information with the product for use in the future.

Product description

Intended use

The Nedis HTPA20EBK is a convection heater with 2 temperature settings.

This product is not intended for professional use.

The protective cover of this product is intended to prevent direct access to heating elements and must be in place when the heater is in use.

Any modification of the product may have consequences for safety, warranty and proper functioning.

Specifications

Product

|

Terrace Heater

---|---

Article number

|

HTPA20EBK

Dimensions (l x w x h)

|

27 x 27 x 82 cm

Weight

|

3 kg

Input voltage

|

220 – 240 V ~ 50 Hz

Maximum output power

|

1200 W

IP rating

|

IP24

Cable length

|

1.4 m

Main parts (image A)

A

1. Heating unit

2. Heating element

3. Protective cover

4. Base stand

5. Power cable

6. Handle

7. Function dial

Safety instructions

WARNING

Ensure you have fully read and understood the instructions in this document before you install or use the product. Keep the packaging and this document for future reference.
Only use the heater indoors or outdoors under roofed areas.
If used outdoors, protect the heater against weather influences.
Only use the product as described in this document.
Do not use the product if a part is damaged or defective. Replace a damaged or defective product immediately.
Do not use the product where splashing of water might occur, e.g. bathroom, swimming pool or close to a washbowl.
Do not expose the product to water or moisture.
Do not drop the product and avoid bumping.
Do not open the product.
Keep the product out of reach from children, infirm persons or animals.
Children and persons with reduced physical, sensory, or mental capabilities or lack of experience may not use the product without supervision.
Do not use the product when the cable or plug is damaged.
Keep hands and utensils out of the protective cover to reduce the risk of severe injury to people or the product.
Children of less than 3 years should be kept away unless continuously supervised.
Disconnect the product from the power source before service and when replacing parts.
Make sure that the function dial is in the OFF position before disconnecting the product.
Make sure that the voltage of your power outlet matches the voltage required by the product.
Keep the product away from flammable objects such as furniture, curtains and similar.
Do not use a damaged product.
Children aged from 3 years and less than 8 years shall only switch on/off the product provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the product in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the product or perform user maintenance.
Do not cover the product.
This heater is not equipped with a thermostat to control the room temperature. Don’t use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
Do not splash water onto the product.
Do not use external timers or remote control systems to switch the product on or off.
Never touch the protective cover, this may cause burns or severe injury.
Do not leave the product unattended when switched on.
Do not let water enter the product.
Do not place the product on moving vehicles or somewhere easy to be tipped over.
Do not move the product during operation.
Do not let the power cable hang over the edge of a table or counter, or touch hot surfaces.
Using an extension cord is not recommended. If an extension cord is inevitable, use one which exceeds the power rating of the heater, is as short as possible and fully extended to prevent overheating.
Unplug the power cable when the product is not in use for a long time.
Do not locate the product immediately below a power outlet.
Unplug the product from the power source and other equipment if problems occur.
Do not unplug the product by pulling on the cable. Always grasp the plug and pull.
Do not use the product in rooms where flammable liquids or gases are used or stored.
This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.

Explanation of the safety symbols on the product

Icon

|

Description

---|---

|

To avoid overheating, do not cover the product.

|

Indication for a hot surface. Contact may cause burns. Do not touch.

Explanation of the symbols on the product or packaging

Icon

|

Description

---|---

|

Electronic equipment needs to bear the CE mark in order to be marketed in the EU. CE marking shows that a product is assessed before being placed on the market and that it meets EU safety, health and environmental protection requirements. CE marking is also sometimes accepted as a means of compliance with type-approval requirements; for example, electronic components that require type-approval and also CE marking for electromagnetic compatibility (EMC) or low-voltage equipment.

|

This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.

Installation

Check the contents of the package
Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.

Installing the product

Place the product on a stable and flat surface.
Do not place the product within 1m of any object, wall or ceiling.

Use

Using the product

Make sure the function dial A7 is switched to the off position before plugging the power cable A5 into a power outlet.

1. Plug the power cable A5 into a power outlet.

The product has three operation modes.

Icon

|

Description

---|---

0

|

Off

1

|

Low (600W)

2

|

High (1200W)

|

Oscillation mode (1200W)

2. Turn A7 to switch between modes.

When you set A7 to the oscillation setting, the fan oscillates on the base stand A4.
The heater is fitted with a tilt sensor. This sensor is a safety precaution that switches off the heater in case it has fallen over.

Switching off the product

1. Set A7 to 0 to switch off the heater.

2. Unplug A5 from the power outlet.

Allow the product to cool down before storage.

Troubleshooting

Problem

|

Possible cause

|

Possible solution

---|---|---

The product does not switch on.

|

Power cable not firmly plugged into power outlet

|

Plug the power cable A5 into a power outlet.

|

The tilt sensor is activated.

|

Place the product upright to deactivate the tilt sensor.

Place the product on a flat, stable surface.

|

An obstruction is inside the product.

|

1.Switch off the product.

2.Unplug the product from the power outlet.

3.Let the product cool down completely.

4.Remove the obstruction.

If the problem persists, switch off the heater and contact the Nedis B.V. service desk via the website: www.nedis.com.

Maintenance

Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
Before cleaning and maintenance, switch off the product and disconnect the power. Let the product cool down completely.
Do not splash water onto the product.
Do not let water enter the product.
Do not clean the inside of the product.
Use a vacuum cleaner with brush nozzle to remove dust from the protective cover.

Warranty

Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
This product is designed for private use (normal domestic use) only. Nedis is not responsible for wear, defect and/or damages caused by commercial use of the product.

Disclaimer

Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.

Disposal

|

This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.

---|---

Declaration of Conformity

We, NEDIS, as manufacturer, declare that product HTPA20EBK from the brand Nedis, produced in China was tested according to all relevant CE standards / regulations and passed all tests.

The complete Declaration of Conformity ( + safety datasheet if applicable ) can be found and downloaded via http://webshop.nedis.com

For other compliant-related information, please contact customer service desk for support:

via website: http://www.nedis.com

via e-mail: service@nedis.com

via telephone: +31 (0)73-5991055 (during office hours)

NEDIS B.V., De Tweeling 28,

5215 MC ’s-Hertogenbosch, THE NETHERLANDS