OPTONICA LED Waterproof Power Supply Instruction Manual
- June 5, 2024
- OPTONICA
Table of Contents
OPTONICA LED Waterproof Power Supply
INSTRUCTIONS FOR USER
TECHNICAL SPECIFICATIONS:
- Product: Waterproof electronic power supply for LED strip
- Input voltage: 100-240V/50-60Hz (PRI)
- Output voltage: 12V DC (SEC)
- Level of protection: IP 66/ IP67
- Electrical protection class: Class
- Ambient temperature: -25°C +40°C
INSTALLATION
For proper installation follow the installation chart shown schema. Connect cables properly on terminal contacts according to the given figure.
IMPORTANT WARNING
Please read the instructions carefully before installation and preserve it well. Recommend, the lamp must be installed and assembled by a qualified electrician. The mains supply should be turned off before installation. Do not turn the lamp on before the end off the installation. Please use proper wire for connection. The installation of power supply into circuits with large inductive loads or voltage surges should be avoided. The output leads should be kept separate and apart from input leads. The length of output leads should be typically 0.5m-2m in order to keep radio interference minimum. Always ensure that the correct type of LED strip is used and that the maximum rating is not exceeded. The label power of LED strip must match the output power of the power supply. The power supply is for indoor and outdoor use. It is not intended that this product is used by children, or persons with reduced physical, sensory or mental capabilities.
Information about the protection of the environment
This product can’t be disposed on the end of service with garbage from
households but should be postponed in a place for recycling electrical and
electronic equipment. The alert is on the markings on the product itself,
user’s manual and box. No part of the specification may be reproduced in any
means or used to make any changes such as translation, transformation or
adaptation without permission from Trgovina Matejic d.o.o.. All rights
reserved. The manufacturer/ distributor takes no responsibility for damage or
injury resulting from improper installation or improper use.
LEGEND
- indoor use only
- please do not use the lamp in damp premises
- level of protection – moisture resistance
- first-class protection
Wireless controller for RGB must be installed on output power supply at 12V
DC for LED products.
PROTECTION FROM BURNS AND FIRE
Do not operate the LED strip if the ambient temperature (Ta) exceeds 45° C (113° C). Do not modify the LED strip in any way not described in this manual or instal than genuine Mitea Lighting parts. Use only accessories approved by Mitea Lighting. If any of the product temperature readouts exceed the level, provide fan assistance to give active cooling to the installation.
TROUBLESHOOTING
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>