OPTONICA 15402 4 Wire Track Light User Manual
- June 1, 2024
- OPTONICA
Table of Contents
OPTONICA 15402 4 Wire Track Light
Product Information
Specifications
- Model: Link Track & Driver
- SKU: 15402
- Input Voltage: INAC100-120V or 200-240V
- Output Voltage: DC48V
- Importer: Prima Group 2004 LTD, Bulgaria
Product Usage Instructions
1. Assemble the Track and Driver
Refer to the below instructions to link the track and driver by L/N poles:
- Lock the track tightly.
- Assemble the track by pulling it straight and flattening it.
- Connect the fixtures to the assembled track parts.
2. Fixtures Assembly
Assemble the track fixing parts near the spotlights with a distance of 5-10cm.
Ensure the track is laid flat on the surface.
3. Wiring Instructions
- Cut the middle of the wire to expose inner copper wire.
- Strip off the outer silicone coating from the wire.
- Connect two copper wires to the DC port of the power supply using the provided specifications.
4. Power Supply Connection
Connect the output of DC48V from the driver to the lighting fixtures.
Note: No need to distinguish between positive and negative terminals.
FAQs
- Q: What should I do if the track is not laying flat?
- A: Make sure to adjust the track and fixtures until it lays flat on the surface to avoid any issues with installation and performance.
- Q: How can I contact the importer for support?
- A: You can reach out to Prima Group 2004 LTD in Bulgaria at the provided address and phone number for any assistance or inquiries regarding the product.
Installation Instruction
- Link Track & Driver by L/N poles (reference below instruction)
- Reference below photos to assemble the track fixing parts.
- Assemble the track, Pull it in Straight in flattening.
- Assemble the Fixtures
Attention:
- Loosen the cap of the fixing fixture,then adjust the flexible track.
- Loosen connection cap of the lamp,then move it for adjustment.
- The weight of all lamps between two fixing should ≤3KG.
- The total power of lamps shall not exceed 80% of driver’s power. Please make sure driver output is same as fixture input(DC48V/ DC24V)before install the lamps.
- Don’t pull the flexible track after installation.
- Note: Different spatial shapes are determined by the location of the fixed point, which should be installed according to the design drawing.
- Due to voltage drop considerations, the track length from the driver to the terminal end to a maximum of 15 meters. Track fixing part assembled nearby spot light in 5-10cm. USER MANUAL SKU:15402
IMPORTER : Prima Group 2004 LTD, Bulgaria, 1784 Soa, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>