Pyle PT260A Digital AM/FM Stereo Receiver OPERATING MANUAL
- June 12, 2024
- Pyle
Table of Contents
Pyle PT260A Digital AM/FM Stereo Receiver
Foreword
Thank you for purchasing this fine PYLE PRO amplifier. Please read this operating instruction carefully before using it. It will acquaint you fully with all its features and help you enjoy your time. The product adopts the most advanced digital technique in the world. It is 4 channels with high power output, so to speak, the real acoustic center of your family movie theatre.
Features
- Stereo Amplifier With A/B Speaker Output
- AM/FM Radio With Digital Display Screen
- Auto Scan, Memory, Radio Station PREVIOUS/NEXT control
- Remote Control Included
- 50 Radio Station Pre-Set Memory
- Volume/Balance/TREBLE/BASS Gain Control For Main Channel
- VOLUME/BASS/TREBLE/ECHO Control For Microphone
- Two Microphone Input Jacks
- Three RCA Input Source
- 110/220V power switch
- AM/FM Antenna Included
Precautions
- Power source-The unit should be connected to a power supply AC~110/60Hz or AC~220V /SO Hz.
- Ventilation-The unit should be situated so that its location or position does not interfere with its proper ventilation. Place the unit at least 10cm away from the walls.
- Water and moisture-The unit should not be used near water-for example, near a swimming pool in a wet basement, etc.
- Electric shock-if a metal object, such as a hairpin or needle comes into contact inside this unit, a dangerous electric shock may result. For families with children, never permit children to put anything, especially metal, inside this unit.
- Enclosure removal-Never remove the enclosure. If the internal parts are touched accidentally, a serious electric shock might occur.
- Abnormal smell-if an abnormal smell or smoke is detected, immediately turn the power OFF and pull out the power cord. Contact your dealer or nearest service station.
Technical Specifications
Technical
| ****
PT260A
---|---
Main Channel Power Output PMPO, 4 Ohms, 1KHz test THD(1KHz)| ****
100WX2
<1%
Normal Load Impedance| 8Ohm
Input Sensitivity Impeda nice
| ****
CD/DVD AUX
| ****
300mV/33k Ohm
Microphone| 6mV/600 Ohm
Signal-to-Noise Ratio
| ****
Pure Amplifier
| ****
76dB
KARAOKE
| ****
71dB
Frequency Range
Frequency Response(40Hz-15KHz)
| ****
± 2dB
Tone Characteristic(100Hz-10KHz}| ± 14dB
Power Requirements| AC~110V/60Hz AC~220V50Hz
Dimension| 19′ (W) x11.4′ (D)x 4.7′(H}inch
Weight| 9.9 lbs
Specifications are subject to change without prior notice
PT260A Front panel
-
POWER SWITCH
Press to switch the power unit ON or OFF. 2. MIC BASS Adjusts the bass of MIC. -
MIC TREBLE
Adjusts the treble of MIC. -
ECHO CONTROL
Turn the knob to adjust the MIC echo level. -
MIC INPUT JACK 1
KARAOKE MIC connects to this jack. -
INPUT
This is used to select the input sources: DVD/CD, TUNER, IPOD/MP3, AUX -
AM/FM SELECTOR
-
MEMORY
-
AUTO
Automatically search the signal of the tuner. -
CH-
This knob is used to select the preview station which has been kept in the system. -
CH+
This knob is used to select the next station which has been kept in the system. -
MENU CONTROL
This is used to increment and decrement level for the selected function of STEREO/MONO, Sharp tuning when in TUNER status and VFD style by adjusting the master volume knob. -
MIC INPUT JACK2
KARAOKE MIC connects to this jack. -
MIC VOLUME
Adjusts the volume level. Turn the knob clockwise to increase the MIC volume. -
BALANCE CONTROL
Turn the knob to adjust the master balance level. -
TREBLE CONTROL
Turn the knob to adjust the master treble level. -
BASS CONTROL
Turn the knob to adjust the master bass level. -
MASTER VOLUME CONTROL
Adjusts the volume level. Turn the knob. clockwise to increase the volume.
PT260A Rear panel
-
TU NERANT
Connect for AM and FM antennas. -
AUDIO INPUT JACKS
Connect the audio output jacks of
IPOD/MP3 IAUX I CD/DVDto these jacks. -
A SPEAKER OUTPUT TERMINALS
Connect your speaker system to
these terminals. -
B SPEAKER OUTPUT TERMINALS
Connect your other speaker system(s) to these terminals. -
110V/220V SWITCH
According to power voltage, push this button to the station of the 11 0V or 220V. -
POWER CORD
Connect to AC 11 0V/60Hz&220V/50Hz outlet.
PT260A Remote
-
Signal input selector
DVD.AUX.IPOD/M PJ.TUNER selector -
Number buttons
Using for st SELECT & STORE -
MEMORY
Aflcr a station has been found, you can store the station by pressing the MEMORY button. -
AUTOSCAN
AM,(/FM auto sc:m selector, scan and store stations automatically. Can store 50 stations. -
ST/MONO
Stereo and mono selector. -
AM/FM
AM/FM selector. -
DISP-/DISP+
Display Down And Up -
VOL-/ VOL+
M:1stcr Volume Oown And Up -
MUTE
Mule Selector -
TUNING TUNING
Tho 1wo keys are used to adjust to the best signal of the stations.
Remote Control Operation
- The remote control should be operated within 6 meters and the scope of 30 in front of the receiver.
- Make sure that there is no big obstacle between the remote control and the machine.
- Remote sensors should be far away from the light, high amounts of light can affect its performance.
PT260A Rear Panel Connecting
Connecting to amplifier
- PyleAudio.com
- www.pyleaudio.com
- 718.535.1800 718.236.2400(fax)
- 1600 63rd Street, Brooklyn NY 11204
FREQUENTLY ASKED QUESTIONS
What is the power output of the Pyle PT260A receiver?
The Pyle PT260A delivers a maximum power output of 300 watts (150 watts per channel).
Does the PT260A have an AM/FM tuner?
Yes, the PT260A includes a built-in AM/FM tuner, allowing you to listen to your favorite radio stations.
Can I connect external devices to the PT260A?
Yes, the PT260A provides multiple input options, including RCA, AUX, and CD inputs, allowing you to connect external devices such as CD players, MP3 players, or smartphones.
Does the PT260A support Bluetooth connectivity?
No, the PT260A does not have built-in Bluetooth connectivity.
Does the PT260A come with a remote control?
Yes, the PT260A includes a remote control for convenient operation from a distance.
Can I connect multiple speakers to the PT260A?
Yes, the PT260A supports stereo speaker outputs, allowing you to connect and drive multiple speakers.
Does the PT260A have tone control options?
Yes, the PT260A provides bass and treble control knobs, allowing you to adjust the tone according to your preferences.
Does the PT260A have headphone output?
No, the PT260A does not include a headphone output.
Can I use the PT260A as a standalone amplifier?
Yes, the PT260A can function as a standalone amplifier by connecting an audio source to its inputs and using the speaker outputs.
Does the PT260A support remote FM antenna?
No, the PT260A does not have provisions for a remote FM antenna.
Does the PT260A support USB or SD card playback?
No, the PT260A does not have USB or SD card slots for audio playback.
Can I connect a subwoofer to the PT260A?
Yes, the PT260A includes a dedicated subwoofer output, allowing you to connect an active subwoofer for enhanced bass response.
Is the PT260A rack-mountable?
No, the PT260A is not designed for rack-mount installations.
Does the PT260A have preset radio stations?
No, the PT260A does not have preset radio station memory.
Can the PT260A be used in a multi-room audio setup?
The PT260A is primarily designed as a stereo receiver for a single audio zone and does not support multi-room audio functionality.
DOWNLOAD THE PDF LINK:Pyle PT260A Digital AM-FM Stereo Receiver OPERATING MANUAL
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>