BOGEN A-series Speaker Terminal Boot ASTB4 Instructions
- June 6, 2024
- BOGEN
Table of Contents
**BOGEN A-series Speaker Terminal Boot ASTB4 Instructions
**
Description
The A-Series Terminal Boot is designed to offer added protection against the
effects of weather on wires and connections made to A-Series speaker model
types A2, A6, and A8. The ASTB4 package contains 4 terminal boots.
Note: The ASTB4 will not fit the A12 model.
Installation
- If necessary, trim the tapering boot sleeve to accommodate the size of the wire bundle to be attached to the speaker (adjust for a snug fit).
- Slide the narrow end of the boot sleeve over the wires. Crimp any lugs onto the wires after inserting the wires through the boot sleeve.
- Secure the wires to the terminals and then slide the terminal boot into place over the terminals, pressing it firmly against the terminal strip for a secure fit. The boot only fits properly in one orientation.
Note: The A2 speaker model does not allow enough space between the housing and the bracket for the boot sleeve to pass between them. Therefore, it is important to install the boot while the speaker is in its approximate final tilt position.
Additional Protection
The terminal boot does not provide a water tight seal for the terminal strip.
It is only designed to minimize the direct effects of weather on the wires and
connections.
Silicone-based caulks can be used to improve the seal of the boot to the
speaker terminal area. If desired, apply a bead to the base of the boot before
pressing it onto the terminal. Silicone sealents with adhesive properties
adhere better than pure silicone products. The boot sleeve exit can also be
sealed, however, be certain to caulk it so that the caulk can be removed later
in case the boot needs to be removed.
Specifications subject to change without notice. © 2002 Bogen Communications, Inc. 54-2085-01B 1104
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>