OPTONICA 5930 LED Flood Light Instruction Manual
- June 5, 2024
- OPTONICA
Table of Contents
OPTONICA 5930 LED Flood Light
Specifications and Technical Data
Luminaire Category:
- LED Floodlight AC220-265V 50HZ/60HZ
- Ambient Temperature: -20C<TA<40’C
- Protection Grade: IP65
- Detection Range: 120°
- Ambient Light: 3-2000LUx (adjustable)
- Time-Delay: min: 10sec+3sec max: 8mint-3min (adjustable)
- Installation Height: 1.8m-2.5m
- Detection Distance: max: 10m (TA25 C) (adjustable)
WARNING
- ENSURE ELECTRICITY IS SWITCHED OFF BEFORE YOU INITIATE ANY MANIPULATIONS.
- Please read carefully the following instructions before commencing installation.
- Some of the necessary accessories and spare parts may not be provided including the junction box.
- The Floodlight must be earthed.
- If the safety shield is damaged, you must replace it immediately, with tempered glass.
- This iS is a professional-use product, any installation and/or service must be undertaken by qualified personnel. Serious injury or death may occur if otherwise.
MOUNTING
- Do not install this product on an unstable surface or any such vibrating one.
- Remove the screw intended for mounting the bracket of the fixture. Remove the bracket. (see fig.2)
- Mark the hole position for fixing the bracket onto the wall. Drill the wall at the marked positions (screw not supplied). (see fig.3)
- Screw the fixing bracket to the wall with a suitable screw (see fig.4)
- Mount the bracket back to the fixture. Adjust the floodlight to the desired position and tighten the serew of the fixing bracket. Connect the mains cable (HOSRN-F3G1.0 mm recommended) with the input lead of our product through the waterproof junction box. Note the Line (-) of the lead. (see fig.5) (Junction box must be IP65 rated or above, ensure to tighten the waterproof screw)
- Turn on the power to make sure the product operates normally. Adjust the irradiation angle according to the intended condition of usage. (see fig.6).
- How to set up the adjustment. (See Tig. .6)
- This product has an override function which is operated by a control switch. Enter override mode: switch (on and off and on) once in 1 second, it will enter the override mode to keep the state of being on. Exit override mode: When the light is on, switch off and after 10 seconds switch on again, it will enter normal mode, night mode with a sensing distance of 10m ( factory setting) and time-delay 8 min.
YOU MUST COMPLY strictly to this instruction, otherwise serious injury or
death may occur
DO NOT tamper with the integrity of this product, it may cause harm to the user otherwise. The power of final interpretation belongs to the manufacturer.
IMPORTER:
Prima Group 2004 LTD, Bulgaria, 1784 Sofña, Mladost 1, bl. 144, Ground Floor;
Phone: +3592 988 45 72.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>