THULE 9034XTR T2 Pro XTR 2-Bike 2-Inch Hitch Bike Rack Instructions
- June 6, 2024
- THULE
Table of Contents
Instructions
Thule T2 Pro XTR
9034XTR, 9035XTR Hitch bike racks
![THULE 9034XTR T2 Pro XTR 2 Bike 2 Inch Hitch Bike Rack
- fig3](https://manuals.plus/wp-content/uploads/2022/04/THULE-9034XTR-T2-Pro- XTR-2-Bike-2-Inch-Hitch-Bike-Rack-fig3-550x173.png)![THULE 9034XTR T2 Pro XTR 2 Bike 2 Inch Hitch Bike Rack
- fig5](https://manuals.plus/wp-content/uploads/2022/04/THULE-9034XTR-T2-Pro- XTR-2-Bike-2-Inch-Hitch-Bike-Rack-fig5-550x288.png)
![THULE 9034XTR T2 Pro XTR 2 Bike 2 Inch Hitch Bike Rack
- fig9](https://manuals.plus/wp-content/uploads/2022/04/THULE-9034XTR-T2-Pro- XTR-2-Bike-2-Inch-Hitch-Bike-Rack-fig9-550x223.png)
General
A.1 Thule assumes no liability for injury to persons, damage to movable or
immovable property, loss of profit, or any other loss or damage caused by the
improper mounting or use of the carrier, including but not limited to mounting
or use in conflict with the assembly instructions, mounting instructions or
any other instructions given, in writing or verbally, by Thule or a Thule
dealer.
A.2 The carrier and its parts must not be modified in any way.
A.3 Consult your Thule dealer if you have any questions about the operation,
use, and limits of the carrier. Read all of the instructions and warranty
information carefully before mounting and using the carrier.
Fitting
B.1 Check the assembly instructions to make sure that all the necessary parts
of the carrier are present.
B.2 Read and follow the assembly instructions and the recommendation list
carefully if the list is included. Then fit the unit in the correct sequence
by following points 1, 2, 3, and so on.
B.3 Do not attempt to fit the carrier in any other way than the way shown in
the mounting instructions.
Loading
C.1 The maximum load for the carrier, as specified in the assembly
instructions, must not be exceeded. In addition, the maximum load recommended
for the vehicle itself always takes priority over the load specified in the
assembly instructions. It is always the lower recommended maximum load that
applies and that must not be exceeded.
C.2 The maximum load for the carrier, as specified in the assembly
instructions, applies to vehicles in motion as well as parked vehicles.
C.3 The load must be carefully secured. Elastic bungees must not be used.
C.4 Check and do not exceed the maximum weight per bike specified in the
mounting instructions.
C.5 When loading bikes on the carrier, always position the largest and
heaviest bikes closest to the car, followed by the smaller and lighter bikes.
C.6 The carrier is constructed to carry only standard bike frames. Tandem
bikes must not be transported on the carrier. Always check and do not exceed
the maximum bike frame size (diameter) specified in the mounting instructions.
C.7 In the case of bikes with carbon frames or forks, always consult the bike
manufacturer or dealer to check if you are allowed to use the carrier.
C.8 We recommend that you use the Thule Bike Frame Adapter 982 for rear-
mounted carriers, such as the tow bar-mounted carriers and rear door-mounted
carriers.
C.9 Thule assumes no liability for any damage to carbon frames or forks
incurred during mounting and/or use of the carrier.
C.10 All easily removable parts of the bikes must be removed before
transportation, including but not limited to child seats, baskets, locks (if
not permanently mounted) and air pumps. These parts can become detached during
transportation because of increased air resistance and vibration and can
constitute a danger to other road users.
C.11 If the vehicle is equipped with an automatic boot or tailgate opening
function, this function must be disabled and the luggage compartment must be
opened manually when the rear-mounted carrier is fitted, to avoid damage to
the vehicle and/or the carrier.
C.12 If necessary, the load must be fitted with the appropriate lights and
warning signs in accordance with local laws.
C.13 In the case of vehicles first type-approved after 1 October 1998, the
rear-mounted carrier and/or the load must not cover the vehicle’s third brake
light. The vehicle’s third brake light must be visible from:
- 10 degrees to the left and to the right of the longitudinal axis of the vehicle
- 10 degrees above and 5 degrees below the horizontal axis
If these figures are not complied with, an optional replacement brake light
must be fitted. National laws must be taken into account while using the
carrier.
C.14 Keep the mounting and safety instructions and (if applicable) the
EC-type approval in the vehicle where the carrier is mounted.
C.15 Not intended for tandems or recumbents.
C.16 Do not install on a trailer or other towed vehicle.
Driving characteristics and regulations
D.1 This product is not approved for and must not be used during off-road
driving. Adapt your speed to the prevailing road conditions and the load being
carried. Check the load fastenings regularly.
D.2 The vehicle driver is solely responsible for ensuring that the carrier is
in perfect condition and that the carrier and load are securely fastened (even
if fitted by a third person).
D.3 Every time the carrier is used, check that the carrier is securely fitted
after driving a short distance (50km) and then at regular intervals. If you
notice any unusual noise, movement of the load and/or carrier, different
behavior of the vehicle, or other unusual conditions, stop and check that the
carrier and load are secured correctly, and in accordance with the mounting
instructions.
D.4 The vehicle’s total length and/or height may increase when a carrier is
mounted. The bikes themselves may increase the vehicle’s total width and
height. Take special care when reversing and/or entering garages or ferries
etc.
D.5 Replace any damaged or worn parts of the carrier immediately. During
transportation, all levers, bolts, and/or nuts must be tightened in accordance
with the mounting instructions.
D.6 Carriers fitted with a lock must always be in the locked position. The
keys must be removed and kept inside the vehicle during transport.
D.7 Be aware that the vehicle’s driving characteristics and braking behavior
(including in curves) might change and that the vehicle might become
vulnerable to side winds when the carrier is fitted.
D.8 Depending on the carrier model, the car’s tail lights can be obstructed.
If that is the case and if the carrier does not already have integrated rear
lights, an external light board must be fitted.
D.9 An additional number plate might be required. This should be attached to
the appropriate part of the carrier in accordance with local laws.
D.10 The vehicle’s speed must always be adjusted to the load being carried and
the current driving conditions, such as the road type, road quality, wind
conditions, traffic intensity and applicable speed limits, but must under no
circumstances exceed 130 km/h. Applicable speed limits and other traffic
regulations must always be observed.
D.11 Drive slowly over speed bumps, maximum speed 10 km/h.
D.12 Be aware that wind noise may be generated during transport and may vary
depending on the vehicle and load.
D.13 For reasons of fuel economy and environmental impact as well as the
safety of other road users, the carrier must be removed from the vehicle when
not in use.
Maintenance
E.1 Clean the carrier regularly using warm water or car shampoo, especially
when using or after using the carrier in coastal areas (the effect of
saltwater) or during periods when salt is applied to the roads (winter time).
E.2 Lubricate the coupling mechanism (but not the surfaces in contact with the
tow ball surface) and other moving parts of the carrier when required.
E.3 Remove the carrier before using an automatic car wash.
E.4 When the carrier is removed from the vehicle, it must be stored in a dry
storage area. All the components of the carrier must be stored safely.
Remember to clean and maintain the carrier in accordance with the
instructions.
E.5 If you lose part(s) of the carrier or part(s) of the carrier wear out,
only use genuine Thule spare parts as replacements. Spare parts can be
purchased from your dealer or manufacturer.
E.6 To ensure that you receive the spare parts quickly and to avoid time-
consuming queries, please provide the relevant product details and the serial
number when placing an order or making an inquiry.
E.7 In order to ensure that you are able to replace lost or defective keys as
quickly as possible, note down the lock and key number which can be found on
your key.
E.8 Check the tightness of all bolts and knobs periodically.
E.9 Check rubber straps for wear and replace if worn.
Thule Inc. • 42 Silvermine Road • Seymour, CT 06483
Thule Canada Inc. • 710 Bernard • Granby QC J2J 0H6
North American Consumer Service:
Toll Free 800-238-2388 / Fax
450-777-3615 •
www.thule.com
Register online at
www.thule.com/register
© Thule Group 2020. All rights reserved.
506-7404-02
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>