Mercury HG630B Spark Huawei Fibre Configuration User Manual

Mercury HG630B Spark Huawei Fibre Configuration

Using your own router? No worries, we’ve got you covered!

Log into the gateway:

1. Ensure your device is connected to the Router (preferably via cable)
2. Open a web browser
3. Type the following in the address bar at the top: 192.168.1.254
4. Default Username: admin
5. Default Password: admin
   This should then give access to the router’s user interface
   (If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds)

How to add correct settings for the Mercury network:

1. From the menu on the left select: Basic
2. From the drop-down menu select: WAN
   On the main page locate: Spark_Fibre or TNZ_Fibre or ETH_VID10 Select this option. Select this option.

Ensure the following settings are changed:

1. Wan Connection: Ticked
2. Service Type: tick Internet (TR069 not ticked)
3. Connection Type: IP Routing (PPP)
4. NAT Type: NAPT
5. Authentication Mode: Auto
6. Connection Trigger: Always On
7. Username: (your mercury acct number)@mercurybroadband.co.nz
8. Password: password
9. Click Submit
10. From the menu on the left select: Link Interface
11. On top of screen locate FIBRE
12.  VLAN ID: 10
13. 802.1P: -1 or 0
14.  Click Submit
    You should now be connected to Fibre!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>