Mercury NF8AC Netcomm Fibre Configuration User Manual
- June 5, 2024
- Mercury
Table of Contents
Mercury NF8AC Netcomm Fibre Configuration
Using your own router? No worries, we’ve got you covered!
Log into the gateway:
- Ensure your device is connected to the Router (preferably via cable)
- Open a web browser
- Type the following in the address bar at the top: 192.168.20.1
- Default Username: admin
- Default Password: password
This should then give access to the router’s user interface
(If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for
10 seconds)
How to add correct settings for the Mercury network:
- From the menu on the left select: Advanced Setup
- From the sub-menu select: WAN Service
In the page Select the Remove tickbox for all connections:
- Select: Remove
- Select: Add
Ensure the following settings are changed:
- Wan Service Int Config: ETH4/ETH4
- Select: Next
- WAN Service Type: PPP over Ethernet (PPPoE)
- Service Decription: (left as is)
- 802.1P Priority: 0
- 802.1Q VLAN ID: 10
- Select: Next
- PPP Username: (your mercury acct number)@mercurybroadband.co.nz
- PPP Password: password
- PPPoE Service Name: Mercury
- All other settings can be left as is
- Select: Next
- Leave this page as is
- Select: Next
- Select anything in the right box and move to left box
- Select: Next
- Select: Apply/Save
You should now be connected to Fibre
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>