Aerpro CHSZ6C Suzuki Steering Wheel Control Interface User Guide
- June 5, 2024
- Aerpro
Table of Contents
Aerpro CHSZ6C Suzuki Steering Wheel Control Interface
ABOUT THIS PRODUCT
CHSZ6C
Analogue Steering Wheel Control Interface for select Suzuki vehicles. Retains
steering wheel control functionality, OEM phone buttons, USB & Aux inputs and
reversing camera (if vehicle is equipped).
WIRING COLOUR CODES
| Purple | Right Rear Speaker + | Yellow | Permanent 12V |
|---|---|---|---|
| Purple/Black | Right Rear Speaker – | Black | Ground |
| Green | Left Rear Speaker + | Red | Ignition 12V |
| Green/Black | Left Rear Speaker – | Pink | Speed Pulse |
| Grey | Right Front Speaker + | Green | Park Brake |
| Grey/Black | Right Front Speaker – | ||
| White | Left Front Speaker + | ||
| White/Black | Left Front Speaker – |
PRIOR TO INSTALLATION
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are using during the installation to avoid damage to the vehicle or product. Aerpro can not be held responsible for the installation of this product.
TECHNICAL SUPPORT
Aerpro want to provide a fast and suitable resolution to any problems encountered during the installation of this product. To get in touch with our dedicated technical support team, please fill in a ticket at aerpro.com/contact and provide as much information as possible.
FITTING GUIDE
-
Remove and disconnect the original head unit.
-
Connect the 12 way molex connector of the head unit patch lead (supplied separately) to the interface.
-
Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit.
NB: This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
Important: This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function.
-
Connect the 14 way molex connector to the interface
-
Connect the male power/speaker ISO harness to the female power/speaker ISO har-ness from the aftermarket head unit. For aftermarket head units without an ISO connector, please refer to “Wiring Colour Codes” on Pg. 2.
-
If the vehicle has OEM USB and Aux inputs, or a reversing camera, these can be retained through the CHSZ6C interface.
To retain Aux: Connect the 3.5mm jack from the interface to the back of the stereo To retain USB: Connect the male USB connector to the back of the stereo
To retain Reversing Camera: Connect the small square white connector from the interface to the vehicle -
Connect the female vehicle-specific connector on the harness to the male vehicle connector from the vehicle. Test head unit for correct operation.
STEERING WHEEL CONTROL FUNCTIONALITY
Original Button
+ Icon
– Icon
Right Arrow
Left Arrow
Mute Icon
Pick Up Icon
Hang Up Icon
Mode
Speech Icon
Function
Volume +
Volume –
Track +
Track –
Mute
Pick Up
Hang Up
Source
Speech
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>