Aerpro CHHO7C Honda Steering Wheel Control Interface Instruction Manual

March 7, 2024
Aerpro

Aerpro CHHO7C Honda Steering Wheel Control Interface Instruction Manual
Honda Steering Wheel Control Interface

CHHO7C

Honda steering wheel control interface for Honda vehicles without CAN-Bus.

Product Contents

  • Interface

  • Harness

  • Instruction

    1. Interface
    2. Male Power/Speaker ISO connector
    3. Vehicle Specific Connector/s

Application

Jazz 2014>

Prior to installation

Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure you use the correct tools to avoid damage to the vehicle or product.
Airprox can not be held responsible for the installation of this product.

Technical Support

Airprox want to provide a fast and suitable resolution should you encounter any technical issues. With this in mind, when contacting Airprox, try to provide as much Information as possible. This will speed up the process and help us to help you.

Please contact us at aerpro.com/contact

FITTING GUIDE

  1. Remove and disconnect the original head unit.

  2. Connect the 12 way Molex connector of the head unit patch lead (supplied separately) to the interface.
    FITTING GUIDE

  3. Connect the opposite end of head unit patch lead to the head unit steering wheel control input on the back of the aftermarket head unit. This may be a 3.5mm jack plug or a wire input depending upon the head unit brand being fitted. Please see the head unit installation manual for further information on where to connect.
    Important Note : This step must be completed before connecting power to the interface. Failure to so do may result in no steering wheel control function.
    FITTING GUIDE

  4. Connect the 14 way Molex connector to the interface.
    FITTING GUIDE

  5. Connect the male power/speaker ISO harness to the female power/speaker ISO harness from the aftermarket head unit.
    FITTING GUIDE
    For aftermarket head units which do not have an ISO connector the interface uses the following wiring colors (where applicable

Wire Color Function
Yellow Permanent 12V
Black Ground
Red 12V Ignition
Orange Illumination
Blue Antenna Remote
Green Park Brake
Purple/White Reverse
Purple Right Rear Speaker +
Purple/Black Right Rear Speaker –
Green Left Rear Speaker +
Green/Black Left Rear Speaker –
Grey Right Front Speaker +
Grey/Black Right Front Speaker –
White Left Front Speaker +
White/Black Left Front Speaker
  1. Connect the female vehicle specific connector to the male vehicle connector. Test head unit for correct operation

STEERING WHEEL CONTROL FUNCTIONS

  1. Volume +
  2. Volume –
  3. Track –
  4. Track +
  5. Source
  6. Pick Up
  7. Hang Up
  8. Speech

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals