cal-royal BW-305 Weather Seal Door Brush strips User Manual
- June 5, 2024
- CAL-ROYAL
Table of Contents
cal-royal BW-305 Weather Seal Door Brush strips
Packaging includes
- Screws for wood and metal doors
Installation Guidelines
CUTTING BRUSH:
- Detach brush prior to trimming.
- Cut off extra brush using a cutting tool (lineman side cutting pliers) and crimp the brush strand ends.
- Re-install the brush until it is level with one end of the retainer and crimp to hold it in place.
DOOR BOTTOM RETAINER:
- Determine the required length, mark and cut the door bottom sweep to full width of the door.
- When trimming, remove parts of the brush seal to be trimmed and use a cutting tool (lineman side cutting pliers) to compress the end of seal. This will retain the brush. Trim the aluminum retainer with a hacksaw.
- Close the door and place door bottom sweep along outside bottom edge of door so that it makes contact with threshold. Mark door in center of slotted holes.
- Drill pilot holes in door at marks.
- Fasten door bottom sweep to door with screws.
- Adjust to ensure firm contact with threshold / above finish floor.
Brush Weatherstrips
Tools Required
- Power tool drill
- Marker
- Caulking gun
- Measuring tape
- Screw driver
- Cutting tools (hacksaw & plier)
Fastener:
Screws Size – #6 x 5/8″ PPHSMS
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>