Ulanzi CG01 Bluetooth Smartphone Cap Grip II User Manual
- June 5, 2024
- Ulanzi
Table of Contents
Ulanzi CG01 Bluetooth Smartphone Cap Grip II
Description
- Indicator Flash
- Cold Shoe Mount
- Trigger
- Phone Clamp
- Handle
- Mirror
- Type-C Cord
- 1/4″ Interface
How to pair Bluetooth with Smartphone?
- Press and hold the Trigger for 3 seconds to turn on the controller, the Indicator Flash will be green.
- Active Bluetooth of your smartphone and start to search.
- Please click “ULANZI” in the device list and start to pair it with the remote controller. When pair successfully, there will be a notification saying connected successfully and the green indicator flash will flicker every 2 seconds.
- Now you can use the Bluetooth remote controller to take photos and record video.
- The controller will go to sleep mode and the indicator flash will lit out without extra operations in 5 minutes, press again it will be activated.
- The controller will automatically shut down if no operation within 30 minutes.
- The controller will automatically shut down in 5 minutes if pair failed.
Install on Smartphone
**
**
**Type-C Cord
**
Bluetooth Remote Controller
Kindly Reminder
- The Bluetooth Controller has a Built-in lithium battery, no need to change the battery.
- The red indicator light of the remote controller will be flashing every two seconds when power is low, please charge it in time.
- Please apply a 5V/0.5A adapter to charge the remote controller. When charging, it will turn on automatically, Red and Green indicator lights will Continue to be on, when power is sufficient, the red indicator light will be off.
Mirror
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>