2BF3JULANZI Bluetooth Self-Timer Instruction Manual
- June 1, 2024
- Ulanzi
Table of Contents
Blue Tooth Self-Timer Instructions for Use
- Open the battery cover on the back of the Bluetooth self-timer, insert the batteryCR2032, and it will work. Press the power on/off button, the blue LED will flash, it canwork normally when in use, when not in use, when disconnected, the product will automatically enter the sleep mode, simple to use, energy saving and environmental protection.
- Turn on the Bluetooth of the mobile phone, search for the Bluetooth device, andafter discovering the Bluetooth selfie device, click to connect and pair, and it canbeused after the connection is successful.
- When you need to pair it with another phone, just press and hold the photo button(3 seconds) or so. Let it follow a phone to unbind it first. Then search for Bluetoothdevice connection pairing, turn on the camera, you can use it, and take pictures freely.
- There is no need to switch buttons between IOS system and Android system, aslong as you connect and pair the corresponding mobile phone, you can use the Bluetooth self-timer to take pictures.
FCC Warning Statement:
Changes or modifications to this unit not expressly approved by the party
responsiblefor compliance could void the user’s authority to operate the
equipment. This equipment has been tested and found to comply with the limits
for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to providereasonable protection against harmful
interference in a residential installation. Thisequipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or televisionreception, which can be determined by
turning the equipment off and on, the user isencouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which thereceiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and(2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>