OPTONICA 8203 Industrial LED High Bay Light Instruction Manual
- June 4, 2024
- OPTONICA
Table of Contents
OPTONICA 8203 Industrial LED High Bay Light Instruction Manual
Industrial LED High Bay light
Please take time to read this leaflet carefully and retain it for future reference.
Diagram:
Important Safety Information
Do not wire this lantern into the lighting circuit – use a switched fuse spur.
Before installation and servicing, disconnect the electrical supply at the
mains.
Carefully observe all instructions or warnings that are labelled on, or
supplied with, your product.
This product is suitable for industrial use. If in any doubt, consult a
qualified electrician.
General Information
Do not mount ceiling/wall fittings onto damp surfaces such as newly painted or
plastered areas as this may cause discolouration of the finish.
Tools which may be required:
- Drill
- Cross Head Screwdriver
- Small Electrical Slotted Screwdriver
- Insulation Tape
Fixing instructions
Do not wire this lantern into the lighting circuit – use a switched fuse spur.
This fitting must be earthed. contact a qualified electrician to install a
suitable earth facility.
Ensure the electricity is turned off at the mains before installing or
maintaining any electrical fitting.
Please note: For new installations, check for any electrical cables or pipe
work (gas/water) in the vicinity of the intended mounting point for this
product, before proceeding with the installation.
Installation:
Note: before installation.
Only use a round cable supplied to connect this fitting. (6mm Diameter minimum.)
This is required in order to create a good water seal when connected to the fitting.
-
-install the ring with the light body..
-
Connect the Main Line to the power wire of the lamp.
-
Ensure the terminal connection is made inside a suitable IP65 rated junction box.(not included)
-
-lnstall the LED High bay lighs on the roof ,ceiling.
This product should be disposed of responsibly at the end of its life. Please
recycle where facilities exist. Check with your Local Authority or retailer
for recycling advice
(Waste Electrical and Electronic Equipment Directive)
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>