AENO ΑΕΚ0003 Electric Kettle Installation Guide
- June 4, 2024
- AENO
Table of Contents
AENO ΑΕΚ0003 Electric Kettle
Introduction
AENO electric kettle is designed for boiling water at home and in the office.
Model : AEK0003 (Plug Type E/F), AEK0003-UK (Plug Type G).
Specifications
Supply voltage : 220–240 V (AC); frequency: 50/60 Hz. Power:
1850.0–2200.0 W.
Net Weight : 1.19 kg. Dimensions (L×W×H): 161×214×269 mm. Volume: 1.7 L.
Power cord length : 0.8 m. Boiling water time: ≤6 min.
Package Contents
AENO electric kettle ( See picture a ), stand, quick start guide
Limitations and Warnings
Use the appliance only indoors at room temperature and no higher than 2000 m
above sea level. Connect the kettle only to a grounded power outlet.
Connect and operate the device only in accordance with its specifications. Do
not disassemble or repair the unit on your own. Children and persons with
disabilities may use the device only under the supervision of adults
experienced in the use of the device. Do not allow children to play with the
device. Make sure no liquid gets on the stand (2) and the power button (4)
(See picture a). Do not immerse the device housing (1), the stand (2) and the
power cord (3) in water. Use the device only with the supplied stand. Do not
plug the unit into an outlet if you notice damage of the housing, stand or
power cord. If the device malfunctions, unplug it immediately. Install the
device stand on a sturdy and stable surface, away from hot surfaces, bathtubs,
showers, swimming pools and other potentially dangerous places. During use,
the device housing heats up to a high temperature. Do not touch the housing
with your hands, lift the device from the stand only by the handle (5). Do not
open the lid (7) ( See illustration b ) during boiling water and the first
5 minutes after boiling. When pouring water out from the device immediately
after boiling, do not bring your hand or other body parts close to the kettle
spout (8). Hot steam can burn the skin. Do not pour water below the “MIN” and
above the “MAX” marks on the inside of the device.
If you have any issues or difficulties using your AENO device, please contact support by email at support@aeno.com or via the online chat at aeno.com/service-and-warranty. Our specialists will help you solve the problem, and you will not have to spend time and effort visiting the shop.
Preparing for operation
Before the first use, fill the kettle to the “MAX” mark, boil and pour the water out.
Operating The Device
Plug in the power cord (3) located on the kettle stand (2) ( See picture c ). To open the lid (6) press the button (7). Pour water (1) into the kettle but do not exceed the “MAX” level. Turn on the switch (4). The LED indicator on the switch will light up. After the water in the kettle boils, the device will turn off automatically. The LED indicator on the switch (4) will go out. Remove the power cord plug from the power outlet when you finish using it.
Maintenance
Remove limescale on the inside of the kettle regularly. When using the kettle
(3–5 times a day) it is recommended to descale it once a month if the water in
your area is hard or very hard. If the water is soft or medium-hard, you can
remove the scale once every 2–3 months. For descaling you can use 8 % vinegar
or citric acid solution (30 g of citric acid per 0.5 L. of water). Pour 0.5 L.
of vinegar or citric acid solution into the kettle and leave it for 2 hours
without boiling.
Then pour the contents of the kettle out and boil the water in it 4–5 times
before the next use. The outer surface of the kettle can be cleaned with a dry
cloth or a cloth dampened in a weak solution of neutral detergent. After
applying the detergent, wipe the surface of the kettle with a clean, slightly
dampened cloth and then wipe it dry. The stand can only be cleaned with a dry
cloth. Never use abrasive cleaners, benzene, thinner, etc. to clean the kettle
and the stand.
Troubleshooting
The device does not turn on. Possible cause: No AC mains voltage. Solution:
check if there is power by plugging in another device.
There is voltage in the mains, but the kettle does not turn on. Possible
reason: lack of water in the kettle or insufficient amount of water. Solution:
Pour water into the kettle above the “Min” mark on the inside of the device.
There is voltage in the mains and water in the kettle, but the device does not
turn on. Possible cause: a short circuit in the electrical circuitry of the
device. Solution: contact the service center.
WARNING! If your problem persists, please contact your local supplier or the service center for support. Please do not disassemble the device or try to repair it on your own.
ASBISc reserves the right to modify the device and to make changes and
additions to this document without prior notice to users.
The warranty period and service life is 2 years from the date of retail sale
of the product.
Manufacturer’s information: ASBISc Enterprises PLC, Iapetou, 1, Agios
Athanasios, 4101, Limassol, Cyprus. Made in China. All trademarks and names
herein are the property of their respective owners. Up-to-date information and
a detailed description of the device, as well as connection instructions,
certificates, information about companies that accept quality claims and
warranties, are available for download at
aeno.com/documents.
Recycling information. This symbol indicates that you must follow the Waste Electrical and Electronic Equipment (WEEE) and Waste Battery and Battery Regulations when disposing of the device, its batteries and accumulators, and its electrical and electronic accessories. According to the rules, this equipment must be disposed of separately at the end of its service life. Do not dispose of the device, its batteries and accumulators, or its electrical and electronic accessories together with unsorted municipal waste, as this will harm the environment. To dispose of this equipment, it must be returned to the point of sale or turned in to a local recycling facility. You should contact your local household waste disposal service for details.
Customer Support
Please contact our online support team if you have any questions or issues
with your AENO device.
This is a better option than visiting the store and will save you time and
effort.
Get Support
aeno.com/service-and-warranty
References
- Home appliances AENO - Smart home appliances on the official website of the manufacturer AENO in Europe
- Documents | AENO in Europe
- Dokumenty | AENO w Polsce
- aeno.com/service-and-warranty
- aeno.com/sk/documents
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>