ELNUR GABARRON BRUME Storage Heater User Guide

ELNUR GABARRON BRUME Storage Heater

WARNING Please read these instructions before installing or using this appliance for the first time.

• The warranty of the fan will not cover any damage caused by non-observance of any of these instructions. The instructions should be retained for future reference. This guide must be kept and given to any new owner.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance must not be  made by children without supervision.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
• Children of less than 3 years should be kept away unless continuously supervised.
• If the product is accidentally flooded with water or other liquid, immediately turn off the fan power switch and let it completely dry before use it again.
• Do not knock or beat this product, repeated knocking may cause internal damage.
• If you do not use this product for a long time, please do not store it in a hot and humid place.
• The fan may only be disassembled or repaired by an authorised service technician.
• Please check that the voltage in the rating label fits the power supply.
• Contact with other metals during charging or operation may cause heat, breakage or fire.
• Prevent the use of extension cables. If this is unavoidable, use an approved cable of sufficient capacity and unwind it completely.
• Prevent the electrical cable from contact with sharp, hot or moving objects. Do not wind it around the fan and do not wind it too tightly.
• Make sure the fan is on a firm, level and horizontal surface during use.
• Do not leave a working fan unattended in a room.
• This device is not suitable for use in wet or damp areas. Do not place it in the vicinity of a tap, bathtub, shower, swimming pool, wash basin or similar, make sure it can never fall into water and  prevent water enters the device. Never immerse the device in water or other liquid.
• Do not place the device in an open window in connection with rain, not on wet surfaces and prevent moisture from being spilled on it.
• Do not hang anything above or over the fan and do not use it in the vicinity of curtains, clothing or other materials that could cause the engine to crash. This can result in overheating or fire.
• Ensure that long hair is not sucked into the fan.
• Keep the suction and discharge grille clean and dust-free and ensure a minimum of 50 cm free space around the fan for the safe operation of the unit.
• Make sure that there are no objects in the vicinity of the fan that can prevent oscillation.
• Never put a finger or anything else through the protective grille into the working fan.
• Do not spray any liquid agents (anti-insect, cleaning or similar) on or in the fan; this can cause physical complaints (especially with children!) or damage the fan.
• Do not store or use the device near acids, alkali, oil and other substances that can cause corrosion.
• The use or charge of this fan is forbidden in any area where there is a presence of gases, explosives or inflammable objects.
• Do not use this fan to dry clothes. Do not cover this fan or put the connecting cable nor any other objects in contact with it.
• The air outlet and the air inlet are provided to ensure the most efficient operation of the appliance and also protect the fan from overheating; therefore, it is essential that at no time are they covered.
• Do not use the fan in dusty environments.
• This fan should be switched off and charge disconnected, before any repair work is carried out or when moving it from one location to another.
• The appliance must be used in such a way that it is impossible to touch it for anyone using a bath, shower, pool or similar. Never touch the appliance when barefoot or with wet or damp hands.
• If the power supply cord is damaged, in order to avoid danger risk, it may only be replaced by an identical one, from a workshop recognised by the manufacturer.
• This appliance is a portable fan. The device must not be fastened to the wall.
• Do not use outdoors.
• Do not use this fan with a programmer, timer or any other device that switches the fan on automatically, since a fire hazard exists if the fan is covered or positioned incorrectly.
• Avoid keeping the unit in direct sunlight for a long period of time.
• The remote contains 2 AAA 1,5V lithium batteries, keep out of reach of small children. Seek Medical advice if swallowed.
• Remove the battery from the remote before storage, or if exhausted to prevent leakage.
• This appliance is intended for domestic use only. Only operate the product when it is fully assembled.
• Do not use in conjunction with or directly next to an air freshener or similar product.
• Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
• Do not permit the area around the appliance to become damp or wet. If dampness occurs, turn the output of the humidifier down. If the humidifier output volume cannot be turned down, use the appliance intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to become damp.
• Unplug the appliance during filling and cleaning.
• Never leave water in the reservoir when the appliance is not in use.
• Empty and clean the humidifier before storage, clean the humidifier before next use.
• Micro-organisms that may be present in the water or in the environment where the appliance is used or stored, can grow in the water reservoir and be blown in the air causing very serious health risks when the water is not renewed. To prevent nucleation, remove residual water from the equipment and water tank every time after three days of use.
• Empty the tank and refill it every 72 hours, before refilling, clean it with fresh tap water or cleaning agents if required by the manufacturer. Remove and scale, deposits, or film that has formed on the sides of the tank or on interior surfaces. And wipe all surfaces dry.
•  Never use without the guards in place. After assembly, do not remove the guards during use or cleaning.
• The symbol on the product or in its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. These instructions are only valid in the EU member states.

 INSTALLATION INSTRUCTIONS

1. Getting started
   Before using the mist fan for the first time:

   • Carefully unpack the misting fan and remove all the packing materials.
   • Please check whether there are any missing parts. The mist fan can be assembled only when the parts are complete.
   • Use a soft cloth to remove any dust on the surface that may happen during packing and transport.
   • Place the mist fan on a flat and stable surface.

2. Assembly instructions

3. Unscrew the screw of the short iron pipe, and then pass the wire through the long iron pipe. Then put the long iron pipe on the short iron pipe. Align the screw hole of the iron pipe on the base, fix it with the unscrewed screws.

4. Install the weight plate on the base first, and fasten it with the M5x25 screws. Cover the metal rod of the 5 wheels with the 5 black plastic sleeves and insert them in the holes under the base.

5. Loosen the fixing screw of the fan body, and then plug the fan body terminal and the terminal wire in the iron pipe. Tighten the screw.

6. Install the rear grid, plastic nut, blades, and blade spinner to the motor shaft and fix in place.

7. Install the front grid and net frame, and secure using the screw on the net frame. Inset the upper flexible hose into the mist vent that is located at the front of the fan grid (ensure the hose is free of kinks)
   Tank assembly instructions

8. Put the water tank on the mist generator, ensuring it is appropriately seated in the recess.

9. Fit the cover to the top of the water tank.

10. Insert the lower flexible hose of the fan body into the water tank cover (ensure the hose is free of kinks)

Filling the water tank

• Take off the cover of the water tank.
• Fill the tank with cold and clean water, making sure not to overfill it.

Attention!

• Ensure the product is unplugged from the mains before filling or refilling the water tank.
• Only use water in the water tank. Do not add any chemicals, oils, or other additives.
• The water must not be warmer than 50°C.

 OPERATION INSTRUCTIONS

When connected to the power supply, the fan is under standby mode. You can control the fan with the control buttons or with the remote control.

1. Fan control panel

2. Remote control signal receiving Indicator lights:

3. Normal mode

4. Timer 0,5h/1h/2h/4 h

5. Sleep mode

6. Speed Low – Medium – High

7. Mist medium

8. Mist max
   Control buttons:
   A. MIST
   B. Timer
   C. Wind Speed
   D. Mode
   E. On/Off

9. Natural mode

10. Oscillation

11. Mist min
    F. Oscillation

A. Mist Button

• Press the “Mist” button to switch the ultrasonic mist on or off. Adjust the mist volume (Max-Medium-Minimum) by pressing the “Mist” button several times.
• When the mist function is selected, the water tank indicator light will be illuminated green.
• If the water tank is empty (or short of water), the water indicator light will be illuminated red.
• The mist function and fan function can be worked independently or together.

B. Timer Button
Press the “Timer” button when the fan is on. The indicator will show the time remaining until the fan is due to switch off. You can select the length of time the fan will be in operation from spans ranging from 0.5 to 7.5 hours in 0.5-hour increments. Press the TIMER button repeatedly, and the sum of the values of the lights is the remaining time until shut down.

C. Wind Speed Button

1. Press the Power “ON/OFF” button to switch the fan ON.
2. Set the fan speed from three options (Low-Medium-High) by pressing the “WIND SPEED” button several times. The LED light will show low speed, medium speed, and high speed correspondingly.

D. Mode Button
The wind mode can be adjusted by pressing the “MODE” button.

• Normal: The fan will operate in high, medium, or low mode as set.
• Natural: The fan will operate at low, medium, and high speeds in different patterns to provide a wind flow that replicated natural airflow.
•   Sleep: Sleep mode can operate at low, medium, and high speeds. In sleep mode, the wind speed will decrease in set patterns before operating at a low speed until shut down.

E. ON / OFF Button

1. Press the “ON/OFF” button to switch the fan on or off.
2. Every 72 hours, the control panel lights flash to indicate that the water tank needs to be cleaned. Press the “ON/OFF” button 5 seconds to reset.

F. Oscillating Button
When you press the “OSC” button, the mist fan head will move continuously from side to side. Pressing the button again will stop the oscillation of the mist fan.
Remote control

• Your fan is supplied with a remote, which allows full control of all the units functions.
• The buttons on the remote have the same effect as the buttons on the main control panel.

Inserting batteries

Insert 2 AAA 1.5V Alkaline type batteries into your remote control

1. Flip the backside of your remote control and pull out battery cover. Insert the batteries in accordance with the instructions and polarity of the batteries.
2. Change the batteries in the same way described above.

Warning:

1. Replace the old batteries with the same type batteries. Otherwise, your heater may not function well.
2. Pull out the batteries in case of long terms of disuse to prevent leakage which may impair your remote control.
3. Do not allow water or liquid to get into the remote control.

 CLEANING AND MAINTENANCE

• Always unplug the fan before cleaning it.

• Clean the water tank and water every 72 hours to prevent the formation of scale, algae, or bacteria.

• If you do not intend to use the fan for an extended period, empty the water tank and dry the water unit with a microfiber cloth.

• See picture below, pull out the rubber stopper (1) from the drain outlet (2) to drain the water from the humidifier base.

• If the fan is to be stored for an extended period (over winter, etc), keep it safe and away from dust or damage and repack in its original packaging: this offers the best protection. Store it in a safe and dry place that is not subject to extremes of heat or cold.

• To avoid damaging the plastic and indicators, do not use any abrasive cleaning agents or chemicals.

• The fan must not be opened by unauthorized persons.

CAUTION: Unplug the fan from the electrical supply source before cleaning. After servicing, any safety device (including grilles and blades) it must be reinstalled or remounted as previously installed. Use a soft damp cloth then wipe with a dry cloth. Do not use harmful detergents. Do not bend the blades.

Please take the fan to a clean point once their useful life is finished, to recycle their materials in the right way.

 TECHNICAL SPECIFICATIONS

• Model BRUME
• Rated Input 75 W
• Width 43 cm
• Depth 40 cm
• Height 125 cm
• Net weight 7 kg
• Voltage supply 230 V
• Isolation class Class II
• Water capacity 2,8 l
• Water consumption < 220 ml/h
• Timer 7,5 hours

+34 91 628 1440

• www.elnurgabarron.es
• www.elnurgabarron.com
• www.elnur.co.uk

As a part of the policy of continuous product improvement Elnur, s.a. reserves the right to alter specifications without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>