DongGuan MingPan Electronic M8801 Keyboard Case User Manual
- June 11, 2024
- DongGuan MingPan Electronic
Table of Contents
DongGuan MingPan Electronic M8801 Keyboard Case User Manual
Pairing Mode
Hold Fn+ for 3 seconds to enter pairing mode while blutooth LED flash,turn on tablet and enable the bluetooth function,search for ” bluetooth click it to pair.
Auto Reconnect
when turn on again,the keyboard will automatically attempt to reconnect within 5 seconds,press any key to wake up the keyboa function .
Power Light Overview
Charging:
Fully Charged:
Low battery:
Power Key
Press once to turn on the keyboard.Hold for 3 seconds to turn o ffthe keyboard.
Standby Mode
The keyboard will enter into standby mode after 10 minutes of inactivity
Backlight
Press to adjust the brightness( 3 brightness level setting,start from the lowest level).
Shortcut Key
Troubleshooting Guide
If the keyboard stop working,please check the following:
- Ensure the keyboard is turned on.
- If the keyboard is out of battery,charge the keyboard.
- if the connection is unstable,turn o ffthe keyboard and wait for 10 seconds before turning it back on.if the problem persists,disconnect the keyboard by going to Setting Bluetoothn- Device list-” bluetooth key board”,and “Delect” or “Forget This Device”,then follow the Bluetooth pairing instruction to reconnect your keyboard.If the keyboard remains unresponsive,repeat the above steps.If you are still experiencing problems,contact our customer service.
Reminder
- Built-in rechargeable battery,can supply power for a few of weeks using.
- In order to prolong batterylife,suggest to turn o ffthe keyboard when not using keyboard for an extended period of time.
FCC:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>