ELNUR GABARRON VENSO DC Low Consumption Portable Fan Instruction Manual

ELNUR GABARRON VENSO DC Low Consumption Portable Fan

Please read these instructions carefully before installing or using this appliance for the first time.

SAFETY WARNING

Please read these instructions before installing or using this appliance for the first time.

• The warranty of the fan will not cover any damage caused by non-observance of any of these instructions. The instructions should be retained for future reference. This guide must be kept and given to any new owner.
• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children must not play with the appliance. Cleaning and user maintenance must not be done by children without supervision.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
• Children of less than 3 years should be kept away unless continuously supervised.
• If the product is accidentally flooded with water or other liquid, immediately turn off the fan power switch and let it completely dry before using it again.
• Do not knock or beat this product, repeated knocking may cause internal damage.
• If you do not use this product for a long time, please do not store it in a hot and humid place.
• The fan may only be disassembled or repaired by an authorised service technician.
• Do not plug the fan at a voltage exceeding the specified voltage.
• Contact with other metals during charging or operation may cause heat, breakage or fire.
• Prevent the use of extension cables. If this is unavoidable, use an approved cable of sufficient capacity and unwind it completely.
• Prevent the electrical cable from contact with sharp, hot or moving objects. Do not wind it around the fan and do not wind it too tightly.
• Make sure the fan is on a firm, level and horizontal surface during use.
• Do not leave a working fan unattended in a room.
• This device is not suitable for use in wet areas. Do not place it in the vicinity of a tap, bathtub, shower, swimming pool, wash basin or similar, make sure it can never fall into water and prevent water enters the device. Never immerse the device in water or other liquid.
• Do not place the device in an open window in connection with rain, not on wet surfaces and prevent moisture from being spilled on it.
• Do not hang anything above or over the fan and do not use it in the vicinity of curtains, clothing or other materials that could cause the engine to crash. This can result in overheating or fire.
• Ensure that long hair is not sucked into the fan.
• Keep the suction and discharge grille clean and dust-free and ensure a minimum of 30 cm free space around the fan.
• Make sure that there are no objects in the vicinity of the fan that can prevent oscillation.
• Never put a finger or anything else through the protective grille into the working fan.
• Do not spray any liquid agents (anti-insect, cleaning or similar) on or in the fan; this can cause physical complaints (especially with children!) or damage the fan.
• Do not store or use the device near acids, alkalis, oil and other substances that can cause corrosion.
• Do not use the fan at temperatures above 40 ° C, near heating equipment and in dusty areas.
• Please make sure to unplug the charging cable when charging is finished.
• Do not charge the product on the surface of inflammable objects such as carpets and quilts.
• If the product cannot be charged, please try changing the charging head or charging cable.
• Do not strike the battery; it may break, become hot and/or cause damage to persons and objects.
• If the product has abnormally high temperature or deformation during charging, please stop charging immediately and contact us for after-sales service.
• Disassembly of the battery or battery components is prohibited. It may cause fire and serious explosion risk.
• If any internal battery fluid contact with skin or clothing, be sure to rinse immediately with clean water, otherwise skin inflammation and other symptoms may occur.
• Do not hit or throw the battery hard, or it will leak, heat or break.
• The use or charge of this fan is forbidden in any area where there is a presence of gases, explosives or inflammable objects.
• Do not use this fan to dry clothes. Do not cover this fan or put the connecting cable or any other objects in contact with it.
• The air outlet and the air inlet are provided to ensure the most efficient operation of the appliance and also protect the fan from overheating; therefore, it is essential that at no time are they covered.
• This fan should be switched off and charge disconnected, before any repair work is carried out or when moving it from one location to another.
• The appliance must be used in such a way that it is impossible to touch it for anyone using a bath, shower, pool or similar. Never touch the appliance when barefoot or with wet hands.
• If the charging cable is damaged, to avoid danger risk, it may only be replaced by an identical one, from a workshop recognised by the manufacturer.
• This appliance is a portable fan. The device must not be fastened to the wall.
• Do not use outdoors.
• Do not use this fan with a programmer, timer or any other device that switches the fan on automatically, since a fire hazard exists if the fan is covered or positioned incorrectly.

MOUNTING AND USING THE FAN

This product is intended for cooling air and/or circulating air in a room. This product is intended for normal indoor household use only. This product is not intended for use in commercial, industrial or outdoor environments.

How to fix support feet

1. Take out the fan, support feet, 2 screws and 2 gaskets from the packaging.
2. Place the support feet steadily, place the fan in the middle of the support feet, put the gasket between the fan and the support feet, insert 2 screws of adjustment knobs into the fan 2 side’s screw hole, and tighten clockwise, as in the picture.
3. Adjust the angle and tighten the knob, then can use the fan.

Main parts

Fixing the fan in the hanging position
The fan can be operated either on its support feet or in a hanging position, as shown in the picture below.

Control panel operation

1. Press “ON”: ON, the fan working, LED display 6(Speed) and display battery level.
2. Press “OFF”: OFF.
3. Press “+” to increase the fan speed, the highest is 9. (High speed)
4. Press “-” to reduce the fan speed, the lowest is 1. (Low speed)
5. Power saving mode
   • When the fan speed is greater than 6 and the battery is about 10%, it automatically drops to 6 (Speed). At this time, the power saving mode is entered and the battery is displayed as “ ”, it needs to be charged.
   • In the power saving mode, pressing “+” cannot adjust the fan speed over 6. Only the battery has reached to the first level, shown as “ ”, then set the fan speed to normal.

CLEANING AND MAINTENANCE

Switch the fan off and remove the plug from the socket if you wish to clean the device or perform maintenance. The fan only needs general, exterior maintenance. Dust it regularly with a soft cloth or duster or use a vacuum cleaner with a soft brush to clean. Ensure that water does not come into contact with anything other than the grille and blades. Never rinse or spray the fan! To prevent material discolouration or deformities, never use aggressive or corrosive (cleaning) products. If the fan is to be stored at the end of the season, repack in its original packaging: this offers the best protection. Store it in a safe and dry place that is not subject to extremes of heat or cold.

Please take the fan fans to a clean point once their useful life is finished, to recycle their materials in the right way. When removing the battery for recycling or disposal, be sure to use insulating tape to insulate the electrodes.

SPECIFICATIONS

Model/VENSO DC

• Power 18 W
• Width 39 cm
• Depth 16 cm
• Height 39 cm
• Weight 3 kg
• Input Supply 5VDC 3A / 9VDC 2A / 12VDC 1,5A (Max)
• Electric isolation Class III
• Battery Li-ion 12.000 mAh

The symbol on the product or in its packaging indicates that this product may not be treated as household waste. Instead, it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of the product. For more detailed information about recycling this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. These instructions are only valid in the EU member states.

ELNUR S.A.

• Travesía de Villa Esther, 11 28110 Algete – Madrid
• Tfno. Atención al Cliente: +34 91 628 1440
• Website:
  • www.elnurgabarron.es
  • www.elnurgabarron.com
  • www.elnur.co.uk.

As a part of the policy of continuous product improvement Elnur, s.a. reserves the right to alter specifications without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>