ELNUR GABARRON P55 Evaporative Air Cooler User Guide

ELNUR GABARRON P55 Evaporative Air Cooler User Guide

IMPORTANT SAFETY INSTRUCTIONS

1. Make sure your electricity supply are 220-240v – 50Hz
2. Use the device only as described in this manual. Other uses are not recommended, as it may cause fire or electric shock.
3. Do not pull out the power cord with a wet hand. This may cause an electric shock accident
4. Do not use the unit in extreme temperatura áreas. Do not expose the unit to the direct sunlight. Only for indoor use.
5. Do not use extensión cord to avoid overheating or fire risk.
6. Do not exceed the maximun level on the water tank
7. Do not move it quickly if there are wáter in the tank in order to avoid splaslh
8. Do not put he unit near explosives, hot oven or hot surfaces.
9. Hold the plug to disconnect it from the socket. Never pull on the power cord.
10. Please, do not use COOL function ofunction in a few ventilated closed área for a long time to avoid high humidity.
11. The unit must be placed on a flat and resistant surface.
12. This appliance is not intended to be used by people (included children) with reduced physical, sensorial or mental abilities, with few experience or knowledge, unless they are under the supervisión of a person responsible of their safety with the use instructions of the appliance. Children should be supervised to ensure they do not play with the device
    • Children under 3 years of age should be kept out of the reach of the appliance unless they are continuously supervised. Children from 3 years and under 8 years should only turn on / off the device as long as it has been placed or installed in its normal operating position and that they are supervised or have received instructions regarding the use of the device in a safe manner and understand the risks that the device has.
    • Children from 3 years and under 8 years should not plug in, regulate or clean the appliance or carry out maintenance operations.
    • This device can be used by children over 8 years and for person with physical, sensorial or mental disabilities or without experience or knowledge as long as they have been properly trained and been supervised for someone who undestand the risks.
13. Switch off and plug off the air cooler before to clean it
14. If you are not going to use the device for a long time, please swith off it and empty the tank.
15. Change the water regulary to kept clean the water.
16. Never immerse the unit, the power cord or rthe plug in water

NOTE
To avoid the danger of electric shock, unplug it from the mains when it is not in use and before cleaning it. If the power cord is damaged, stop using it immediately and take it to the service center for repair.

PRODUCT DESCRIPTION

FIRST USE

1. Open the box and unpack the product.
2. Make sure there is enough space to pull all parts before starting assembly
3. Necessary to remove the water tank to fill it.
4. Put clean water until MAX signal. Replace the water tank at its place and dry any piece of water. If you have any difficulty placing the tank in the correct positionm, please read “cleaning and maintenance”
5. To use ice cubes, open the tank and insert them inside the water tank
6. Plug in the unit

OPERATING MODES

Control panel

1. On/Off Button
   a. Plug in the unit. Press On/Off button. The power light will turn on and the unit will start working.
   b. Press On/Off button again to turn off the unit.

2. AI Button
   Automatically adjust the fan speed according to the ambient temperature, the LED indicator will light up when it is in the working state.

3. Shake Button
   Press the button once, the upper and lower LED lights will be on, the two fans will shake its hands in same direction to the left and right. Press the button again, one of the upper and lower fans can be selected to shake its head. Working instruction: Upper and lower fans shake their heads, lower fan shakes its head, upper fan shakes its head, and then stop shaking their heads.

4. Speed Button
   Press the Speed button to select 3 different wind speed
   Press once “LO “ lights up for Low wind speed
   Press twice “MI” lights up for Medium wind speed
   Press thrice “HI” lights up for High wind speed

5. Timer Button
   Press the timer button to seat the length of operation from 1 up to 7 hours in the setting of 1 hour, 2 hour, 4 hours. Press timer button once to shift the setting to the next time zone The unit works continuously if no time indicator lights is on.

6. Cooler Button
   Press the cool air button, the cool indicating light will be in and the unit starts to pump up water and shower the water curtain. The humid and comfortable cool wind comes out. When there is no water in the water tank, the LED indicator will show red, and the beeping sounded.

7. Mode/UV Button
   By pressing the mode/UV button you can control which fans operate, both together, upper only or lower only. The relevant lights illuminate to inform you of your selection. And the UV function will be on automatically when the fan starts to work and sterilize the air quality.

NOTE:

1. Please fill in with water before using the Cool Air function. If the water is under low level or without water, the Cool Air function will not be activated until the water tank is refilled.
2. The unit can be used without water as a normal electric fan. Please keep the “Cooler” button at off mode during the humid weather.
3. Place the ice cubes or ice pack into the water tank can lower the water temperature and strengthen cool air function.

CLEANING AND MAINTENANCE

BEFORE CLEANING THE DEVICE, MAKE SURE to turn off and unplug the plug to avoid risk of electric shock.
In order to prolong the life of the product and maintain the best possible performance, it is recommended to clean the unit regularly

1. General cleaning.
   Do not use gasoline, solvents or other chemical products for cleaning and maintenance. Use a soft cloth for cleaning.

2. Filter cleaning.
   Remove the dust filter and wash it under water using a soft brush or cloth.

3. Water tank cleaning.
   Remove the water tank by pulling it. Before the tank is completely out, lift it up to liberate the locator from the clamp below it. Use a wet cloth with neutral detergent for cleaning. Rinse with water, dry off and instal the tank again.

4. External Parts Cleaning.
   Use neuter detergent and soft cloth for cleaning .
   

NOTE:

1. The safety switch system will stop the unit automatically while the back cover is removed.
2. In order to keep good condition for humidifying and purifying, please clean the filtering system frequently.
3. Never immerse the unit, power cord and plug into water.
4. Do not attempt the unit; must be repaired in an official technical service.

TROUBLE SHOOTING

plugged into the electrical power. PressMOOE.Take the device to technical service.
The unit can not be off.| The button OWOFF has not been pressed Safety switch is released.Some piece may be damaged.| Press the OWOFF button to switch off the unit. Check the filter are correctly installed.Take the device to technical service.
The device has abnor- ma( noise.| Foreign objets got inside. The engine is damaged.| Remove possible objects Of any). Take the device to technical service.
COOL mode (humidifier) does not work.| Low level or lack of water in the tank. inner nner water pipe has been draped off. The pump may be damaged.Fill the water tank.| Reconnect the water pipe.Take the unit to the technical service.
The lowers do notlateoscillate| The engine is damaged.| Take the unit to the technical service.
The air is not cold| The back finer may be blocked by dust. There is not enough water.Cool air button not pressed.| Add water to the tank. Press the COOL button. Replace filter.

STORAGE

• If you are travelling, or you are not going to use the device for a long period of time, must be switch it off and unplug it. Remenber empty the tank as otherwise, the life of pomp and the case will be affected.
• Clean the unit before storing it. Remove honeycomb filter, clean it and dry it off before storing it. This will prevent it from becoming smelly or moldy after it has not been used for a long time. Cover the device with a plastic bag to prevent it from picking up dust.
• Store it in a dry and ventilated place.

SPECIFICATIONS

Voltage: 220-240V ~ 50 Hz
Power: 70W
Water tank capacity: 7 l
Dimensions: 334 x 308 x 779 mm // 13,15 x 12,13 x 30,67 inch
Net Weight: 7,25 kg // 16 lbs

IMPORTANT

1. The unit is designed for indoor household use only.
2. Commercial or industrial users will not obtain the regular warranty as stated in the terms of the warranty cards.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>