everActive WL-400 Worklight Rechargeable Batteries Flashlights User Manual
- June 9, 2024
- everactive
Table of Contents
Worklight WL-400
User Manual
WL-400 Worklight Rechargeable Batteries Flashlights
- SMD LED
- COB LED.
- Switch on
- Magnet.
- Mounting
Specification
| Light sources | lx SMD LED 1W |
|---|
lx COB LED 5W
Light power| Max 400 Im
Operation modes| SMD LED 100% (white)
COB LED 100% (white)
COB LED 50% (white)
COB LED flashing (red)
Power supply| 3x AA/R6 1,5V
Runtime| SMD/COB 100% – 5h COB 50% – 9h
Weight| 140g
Dimensions| 196 x 25 x 30mm
Waterproofness| IP 54
Material| Aluminium, PA, PMMA
General information
The Everactive WL-400 torch is equipped with two light sources, a clip holder
and magnet for mounting. The device has four operating modes: white top light,
100% white front light, 50% white front light, and flashing front light in
red.
Using flashlight
The button located under the COB diode is used to switch the torch on and
change operating modes. After cycling through all the light modes flashlight
will turn off.
Package contents
-EverActive WL-400,
-User manual.
Safety precautions
-Read user manual carefully before first use
-Comply with the polarity of the battery.
-If your body comes into contact with a corrosive substance leaking from the battery, rinse skin immediately with clean water and contact a doctor immediately.
-Remove the battery from the torch in case of long-term storage.
-Do not open, charge or throw batteries into fire.
-Keep batteries out of the reach of children.
-Store the torch away from UV radiation, moisture and chemical products.
-Protect the product from unsupervised use by children and ineligible persons.
-Do not disassembly, do not destroy, do not cause excessive shock and do not incinerate the device. Do not crush, protect against mechanical damage and fall. Do not place heavy objects on the unit.
-Avoid the sources of heat, flammable gases, protect against moisture and flooding.
-Do not allow foreign objects to enter the charger
-Do not operate device if it has beet wet or otherwise damaged. This could result in electrical shock or fire.
-Do not leave the device unattended during operation.
The product should be disposed of properly according to applicable law. At the
end of life the product should be passed to the waste collection, electronic
recycling point. It is not allowed to dispose the product with the regular
household wastes. By proper disposal you contribute to the protection of the
environment and natural resources. More on:
www.everActive.pl/eco.
Warranty
Baltrade will repair or replace your device free of charge if it is proven to
be defective within two years from the date of purchase. Baltrade shall not be
held liable for any damage caused by misuse or not using the product in
accordance with this manual. Warranty will be invalid if the device was
modified in any way, disassembled, exposed to moisture, liquids, ingression of
solid objects, extreme thermal or environmental conditions. If the device was
proven to be defective, it will be repaired or replaced. In the event of a
warranty claim, please contact the retailer from whom you purchased your
device. You can also send it together with all accessories, to the address
below:
Baltrade sp. z o.o.
Kartuska 493
80-298 Gdansk, Poland
E-mail: support@baltrade.eu
Receipt or invoice as a proof of purchase should beprovided. This warranty
does not affect and is in addition to legal (statutory) rights under
applicable national laws relating to the sale of consumer products.
Baltrade sp. z o.o., ul. Kartuska 493, 80-298 Gdansk, Poland
www.everActive.pl