everactive 83000023 Sundance Device Instructions

: June 5, 2024
: everactive

Table of Contents

Hardware needs
Connecting the DUT to your PC
Operating the Wake-up Dongle using Python:
Host Labeling Instructions
Antenna Information
Installation Notes
Integration instructions
FCC warning:
Contact Us
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

everactive 83000023 Sundance Device Instructions

Hardware needs

Wake-up dongle with programmed firmware image
Window 10 PC w/ USB port
JLink programmer

Connecting the DUT to your PC

Connect the JLink programmer to the USB serial port on your PC or a USB powered HUB. The Sundance module can remain physically connected inside the larger Everactive gateway unit (see figure below).

Connect the JLink programmer

Operating the Wake-up Dongle using Python:

Install the python package (internal to Everactive)

pip3 install -i http://python-registry.psikick.com –trusted-host pythonregistry.psikick.com wakeup_device
pip3 install –upgrade -i http://python-registry.psikick.com –trusted-host python-registry.psikick.com wakeup_device

Open a command line prompt to run commands to configure Boomerang

Run wu_fcc –h to see configuration options

Configuration options

Run the script starting with wu_fcc followed by the commands to program the transceiver.

The wakeup.py script can operate the following functions:

Vary transmit output power
Hop across all channels
Sweep all channels
Specify channels
Receive packets

Example: See configuration options: wu_fcc –h
Example: Send a wake-up message: wu_fcc –search –wu –power 30

Host Labeling Instructions

Place on exterior of host where visible to the end user.

Contains FCC ID: 2AO7C-83000023
Contains IC: 23743-83000023

Antenna Information

Approved Antennas

Laird 902 MHz – 928 MHz Waterproof Dipole 2 dBi Antenna, IP67

Installation Notes

The modular transmitter is permanently attached inside an enclosure and the entire process is controlled by Everactive. The external antenna is mounted using a reverse polarity SMA connector.

Integration instructions

Everactive will use a reverse-SMA to attach the external antenna at the exterior of the host unit

FCC warning:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Canada (IC) warning:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

a. This device may not cause interference, and
b. This device must accept any interference, including interference that may cause undesired operation of the device.

RF Exposure and Separation Distance:

For safe operation, the minimum separation distance should be 20cm.

Note:
The modular transmitter is only FCC authorized for the specific rule parts listed on the grant, and the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
If the product is being marketed as Part 15 Subpart B compliant (when it also contains unintentionalradiator digital circuity), then the grantee shall provide a notice stating that the final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.