SKYDANCE T20 Wall Mounted Touch Panel User Guide
- June 10, 2024
- SKYDANCE
Table of Contents
T20 Wall Mounted Touch Panel
User Guide
Features
- Touch panel 1/2/3/4 zone dimming switch RF remote.
- Each zone can remote control multiple Skydance’s 2.4G LED controllers.
- Ultra sensitive high strength glass touch panel.
- Touch keys with chord tones and LED indicator.
- Free installation, no wiring, removable.
- AAA x 2 battery powered.
- White & Black glass panel available.
Technical Parameters
Input and Output
Output signal| RF (2.4GHz)
Working voltage| 3VDC (AAA x 2)
Working current| ＜5mA Without tune
＜20mA with tune
Standby current| ＜20μA
Standby time| 1 year
Remote distance| 30m (Barrier-free space)
Environment
Operation temperature| Ta: -30ºC ~ +55ºC
Case temperature (Max.)| T c: +65ºC
IP rating| IP20
Safety and EMC
EMC standard (EMC)| ETSI EN 301 489-1 V2.2.3
ETSI EN 301 489-17 V3.2.4
Safety standard(LVD)| EN 62368-1:2020+A11:2020
Radio Equipment(RED)| ETSI EN 300 328 V2.2.2
Certification| CE,EMC,LVD,RED
Warranty
Warranty| 5 years
Weight
Net weight| 160g
Gross weight| 190g
Mechanical Structures and Installations
Installation diagram:
Typical base as below:
To fix the panel, two options are offered for selection:
Option 1: fix it on the wall with two screws.
Option 2: adhere it to the wall with paster.
Key function
I — ON key
Short press: Turn on the light of each zone.
Long press(1-6s): Dimming up when light is on.
O — OFF key
Short press: Turn off the light of each zone.
Long press(1-6s): Dimming down when light is on.
Long press(5s) : Turn on or turn off tone when light is off.
Touch Panel work as RF remote (two match ways)
End user can choose the suitable match/delete ways. Two options are offered
for selection:
Use the controller’s Match key
Match:
Short press match key, immediately press ON key of the touch panel.
The LED indicator fast flash a few times means match is successful.
Delete:
Press and hold match key for 5s to delete all match.
The LED indicator fast flash a few times means all matched remotes were
deleted.
Use Power Restart
Match:
Switch off the power of the receiver, then switch on power, repeat again.
Immediately short press ON key 3 times on the touch panel.
The light blinks 3 times means match is successful.
Delete:
Switch off the power of the receiver, then switch on power, repeat again.
Immediately short press ON key 5 times on the touch panel.
The light blinks 5 times means all matched remotes were deleted.
Safety information
-
Read all instructions carefully before you begin this installation.
-
When installing battery, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery. -
If no response from the receiver, please re-match the remote.
-
Gently handle remote, beware of falling.
-
For indoor and dry location use only.
T20, T20-1, T20-2, T20-3
Wall Mounted Touch Panel
User Manual Ver 1.0.7
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>