V I V O STAND-TV65B Black Easel Studio TV Stand Instruction Manual
- May 21, 2024
- V I V O
Table of Contents
STAND-TV65B Black Easel Studio
TV Stand
Instruction Manual
STAND-TV65B Black Easel Studio TV Stand
https://vivo-us.com/products/stand-
tv65b
Scan the QR code with your mobile device or follow the link for helpful videos
and specifications related to this product. https://vivo-us.com/products
/stand-tv65b
GET IN TOUCH Monday-Friday from 7:00am-7:00pm CST
WARNING!
If you do not understand these directions, or if you have any doubts about the
safety of the installation, please call a qualified technician. Check
carefully to make sure there are no missing or defective parts. Improper
installation may cause damage or serious injury. Do not use this product for
any purpose that is not explicitly specified in this manual. Do not exceed
weight capacity.
We cannot be liable for damage or injury caused by improper mounting,
incorrect assembly or inappropriate use.
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT
TIPOVER:
- NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF TV OR STAND.
- USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIPOVER.
WARNING: CHOKING HAZARD
SMALL PARTS – NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
PACKAGE CONTENTS
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
TOOLS NEEDED
ASSEMBLY STEPS
STEP 1
Remove the cable management cover from Center Leg (B). Assemble Center Leg (B)
to Pole (E) using M5x12mm Screws (S-A) and a Phillips screwdriver. Screw Legs
(A) into base of Pole (E).
STEP 2
Adjust collar height on Pole (E) using 4mm Allen Wrench (T-B).
STEP 3
Remove the screw from the center clamp of Lower VESA Bracket (C) and open the
clamp.
STEP 4
OPTION A: Flat Back Monitor
Position Lower VESA Bracket (C) and Upper VESA Bracket (D) horizontally on the
back of the TV, making sure Upper VESA Bracket (D) is on top and Lower VESA
Bracket (C) is below.
Secure using Screws (M-A or M-B) with Square Washers (M-F) and M5 Washers
(S-D), with Security Clips (G) installed to top holes.
OPTION B: Large or Curved Back Monitor
Position Lower VESA Bracket (C) and Upper VESA Bracket (D) horizontally on the
back of the TV, making sure Upper VESA Bracket (D) is on top and Lower VESA
Bracket (C) is below. Secure using Screws (M-C, M-D or M-E) with Square
Washers (M-F) and Spacers (M-G, M-H) with Security Clips (G) installed to top
holes.
STEP 5
Slide the TV with VESA brackets (C, D) onto Pole (E). Close the clamp on Lower
VESA Bracket (C) over Pole (E) and secure with previously removed screw.
STEP 6
Remove the cable management cover from Pole (E) and route cables through the
pole and Center Leg (B). Reinstall cable management covers.
STEP 7
OPTION A: Wood Stud Installation
Use a stud finder and a level to locate two adjacent studs. Using Cable Clamps
(F) as guides, mark drilling locations on the wall. Drill a 1.6” (40mm) deep
hole using a 1/8” (3.5mm) drill bit. Mount Cable Clamps (F) to wall using
ST4.8x38mm Screws (S-B). Thread Steel Cable (H) through Security Clips (G),
then through the center holes in the Cable Clamps (F) as shown, then tighten
using 2mm Allen wrench (T-A).
OPTION B: Concrete/ Brick Installation
Using Cable Clamps (F) as guides, mark drilling locations on wall. Drill holes
at least 1.6” (40mm) deep using a 9/32” (7mm) drill bit. Insert Concrete
Anchors (S-C) in holes and mount Cable Clamps (F) to the wall using ST4.8x38mm
Screws (S-B). Thread Steel Cable (H) through Security Clips (G) and through
the center holes in the Cable Clamps (F) as shown, then tighten Cable Clamps
(F) using 2mm Allen Wrench (T-A).
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
Open Monday – Friday 7:00am – 7:00pm CST,
our dedicated support team can offer immediate assistance with rapid response
times. If any parts are received damaged or defective, please contact us. We
are happy to replace parts to ensure you have a fully functioning product.
309-278-5303| AVG. RESOLUTION TIME
(within office hrs): 5M 4S
---|---
www.vivo-us.com
Chat live with an agent!| AVG. RESOLUTION TIME (within office hrs): < 15 M
****help@vivo-us.com| AVG. RESPONSE TIME (within
office hrs): 1HR 8M
– 23% within < 15m
– 38% within < 30m
– 61% within < 1hr
– 83% within < 2hr
– 92% within < 3hr
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT:
www.vivo-us.com
References
- Register a .US.COM domain today!
- VIVO - Desks, Monitor Mounting, and More Home & Office Solutions – VIVO - desk solutions, screen mounting, and more
- Steel Easel Stand for 45" to 65" TVs – VIVO - desk solutions, screen mounting, and more