WATTECO 50-70-080 Modbus Class A LoRaWAN Master Sensor User Guide
- June 3, 2024
- WATTECO
Table of Contents
WATTECO 50-70-080 Modbus Class A LoRaWAN Master Sensor
Start
Provision the device on your LoRaWAN® network with the keys available on the secure platform.
ON
OFF
Video:
ON – OFF
Connectors
The 120Ω line termination jumper can be enabled or disabled at the user’s discretion for proper RS485 bus communication.
Use a flexible cable with a sheath with a diameter between 2.5mm and 6.5mm and single-stranded (or multi-stranded with crimp) 20-26AWG wires.
Hold the base(1) of the cable gland and slightly loosen the nut(2).
Thread the cable, taking care not to damage the seal(3).
Strip the cable for about 10cm. Adjust the cable and retighten the nut.
Setting up
Please note that after installation of the railDIN kit, the protection rating of the housing will change to IP50.
Radio propagation
Characteritics
Reference | 50-70-080 | 50-70-109 |
---|---|---|
Class | A | C |
Power Level | +14 dBm | +14 dBm |
**Measures :** | Modbus RS485 | Modbus RS485 |
Antenna | Interne |
Internal
| Interne
Internal
Casing materials| ASA/PC| ASA/PC
IP rating| IP55| IP55
SITE SUPPORT
https://support.watteco.com/
CERTIFICATIONS
Watteco represented by JC LE BLEIS, declares that the radio equipment type 50-70-080 / 50-70-109 is in conformity with Directive 2014/53/EU (RED) and UKCA. The full text of the EU and UKCA Declaration of Conformity is available at the following web address: https://www.watteco.com/assistance/download- center/
References
- support.watteco.com/
- Concepteur et fabricant de capteurs transmetteurs radio connectés IoT - WATTECO
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>