nke WATTECO PT 1000 LoRaWAN Class A Temperature Sensor User Guide
- June 4, 2024
- nke WATTECO
Table of Contents
nke WATTECO PT 1000 LoRaWAN Class A Temperature Sensor
OVERVIEW
Start
Provision the device on your LoRaWAN® network with the keys available on a secure platform.
ON
OFF
Connectors
The PT1000 sensor is supplied without a probe. Pass the cable through the cable gland
Setting up
Please note that after installation of the RailDIN kit, the protection rating of the housing will change to IP50.
Warning
Probe 2 is red: to be installed on hot pipes
Probe 1 is blue : to be installed on return pipes
Temperature measurement on tube
Tighten the clamp without crushing the probe. Insulate the probe with the tape.
Temperature measurement with the thermowell
Fix the cable on a support point with a Rilsan type clamp
Dimensions : Ø 5mm / Length 24mm
Radio propagation
For the sensor communicates correctly, the number of obstacles should be limited to avoid excessive radio attenuation.
Characteritics
SITE SUPPORT
CERTIFICATIONS
Watteco represented by JC LE BLEIS, declares that the radio equipment type 50-70-163 / 50-70-043 / 50-70-200/50-70-164 / 50-70-126 is in conformity with Directive 2014/53/EU (RED). The full text of the EU Declaration of Conformity is available at the following web address: https://www.watteco.com/assistance /download-center/
Thanks for choosing WATTECO devices
References
- support.watteco.com/
- Concepteur et fabricant de capteurs transmetteurs radio connectés IoT - WATTECO
- Centre de téléchargement - WATTECO
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>