WATTECO Inclin’O Remote Monitoring User Guide
- June 3, 2024
- WATTECO
Table of Contents
WATTECO Inclin’O Remote Monitoring
Start
Provision the device on your LoRaWAN® network with the keys available on The secure platform.
ON
OFF
Video :
ON – OFF
Installation Setting up
Default: double-sided pads
Double-sided pads
Finish cleaning the surfaces to be bonded with the 3M wipe supplied with the sensor. Place the double-sided pads (supplied with the sensor) on the back of the case. Place the case in position, press down hard (~10kg)
- Rotate the 2 small covers of the housing to screw in the 2 magnets, inserting the lock washer under the screw head. Make sure the metallic surface is flat and clean.
Rotate the 2 small covers on the enclosure to screw the collar brackets to the enclosure, inserting the lock washer under the screw head Pass the clamp through the slots in the clamp holder and around the post. Then tighten the clamp firmly.
Radio propagation
Avoiding obstacles for better radio propagation.
Check the radio coverage with the Netw’O.
Characteristics
Reference | 50-70-201 |
---|---|
Class | A |
Power Level | +14 dBm |
Measures : | Inclinaison / Tilt |
Antenna | Interne / Internal |
Casing materials | ASA UL 94HB |
IP rating | IP67 |
SITE SUPPORT
https://support.watteco.com/
CERTIFICATIONS
Watco represented by JC LE BLEIS declares that the radio equipment type 50-70-201 is in conformity with Directive 2014/53/EU (RED) and UKCA. The full text of the EU and UKCA Declaration of Conformity is available at the following web address: https://www.watteco.com/assistance/download-center/
References
- support.watteco.com/
- Concepteur et fabricant de capteurs transmetteurs radio connectés IoT - WATTECO
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>