WOODBRIDGE LB428-L Acrylic Rectangular Alcove Soaking Bathtub in White with Left Drain Installation Guide
- June 1, 2024
- WOODBRIDGE
Table of Contents
WOODBRIDGE LB428-L Acrylic Rectangular Alcove Soaking Bathtub in White
with Left Drain
Certified to the following Codes & Standard
- UL 1795 Safety Standard for Hydromassage Bathtubs (UL1795)
- ASME A112.19.7 / CSA B45.10) – Hydromassage Bathtub Systems
- CSA B45.5/IAPMO Z124 – Plastic Plumbing Fixtures
- International Plumbing Code® (IPC)
- International Residential Code® (IRC)
- Uniform Plumbing Code® (UPC)
- National Plumbing Code of Canada® (NPC)
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION.
CAUTION 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT
This products must be installed by a fully insured and licensed plumber only.
Installation of any our product by anyone other than fully insured and
licensed plumber shall void limited warranty. We recommends that such licensed
plumber has experience in the installation of products.
We are not responsible for local code compliance for this product. Building
and plumbing codes may vary from state-to-state in accordance to your
location. We are not responsible for providing any compliance certifications.
Under no circumstances we shall not be liable for any incidental damages
sustained in connection with this product Neither manufacture, nor
distributor, nor retailer is responsible for water damage or flood caused due
to use of this product. Under no circumstances We shall not be liable for any
and all fees, cost of installation/reinstallation/removal, subsequent damage
or transportation in case of the product defect
Customer Service Phone: 562-229-0088. (Monday – Friday 9 AM – 5 PM Pacific Time) Or Email: help@woodbridgebath.com
TOOLS REQUIRED FOR INSTALLATION (NOT INCLUDED)
OTHER TOOLS MAY BE REQUIRED
First ensure that the subfloor is level.
If needed, level subfloor with leveling compound or mortar over the entire
area of installation.
| Model | A | B | C | D |
|---|---|---|---|---|
| LB666-R | 60” | 30” | 21-5/8” | 10-1/4″ |
Cut subfloor to accommodate plumbing in compliance with local plumbing and
building code.
Verify your bathtub for final dimensions.
Position bathtub.Verify that the draining pipe location matches the actual location of the bathtub drain.Remove the bathtub.
| Model | A | B | C | D |
|---|---|---|---|---|
| LB428-L | 60” | 30” | 21-5/8” | 10-1/4″ |
The bathtub can be leveled by adjusting the feet.
Check your adjustment with a level
Lock the adjustment by tighten the hexagon nut.
The bathtub must be tested before installation is completed. Fill the tub to the overflow and inspect it for leaks. Tighten any loose connections.
Apply silicone sealant to seal the joints between the bathtub rim and the finished wall.
Reference for Correct Tile Flange Installation . Use drawing below as a reference guide for rough-in measurements.
IMPORTANT SAFETY RULES
ATTENTION! ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB
WARNING
- The bathtub must be installed and used as described in this manual
- Use caution when entering or exiting the bathtub
- Do not permit children or persons with infirmities to use the bathtub without supervision of an adult
- People using any medications or having adverse medical history must consult a physician prior to use of the bathtub to avoid potential hyperthermia and possible drowning
- Water temperature over 100ºF may cause hyperthermia and/or other health problems. Check water temperature and adjust it for your personal comfort
- Never use bathtub while intoxicated, after taking meals or any alcoholic beverages. Consuming alcoholic beverages before or during bathing will cause drowsiness and may result in hyperthermia, loss of consciousness, or even drowning
- If you are pregnant or you feel that you are may be pregnant, consult your doctor before using the bathtub
- Never use any electrical devices such as hair dryer, lamp, telephone, tv, radio, or others within 5 feet of the bathtub
- Do not overfill the bathtub before enetering. Entering the bathtub when filled will cause overflow and slippery conditions. Use extreme caution when entering and exiting
Care and Cleaning
- Most dirt will wash off with mild soap and warm water.
- For tough spots, use liquid dish washing soap or non-chlorine bleach.
- Do not use abrasive material such steel wool or scouring pads to clean the acrylic surface.
- Always test the cleaning solution on a small area before using it on the entire surface.
- Do not allow cleaning to soak on the acrylic surface.
- Rinse thoroughly with water immediately and wipe dry with soft cloth.
Repair and Maintenance
- Use liquid polish compound such as Gel-Gloss Kitchen and Bath Polish(TM) to keep the original shine of acrylic surface.
- Light scratches can be removed with polishing compound for automobiles.
- For deeper scratches use wet sandpaper (1500 grit or higher). Always add water when sanding and lightly sand the area larger than the scratch in a circular motion to remove the scratches. Repeat until the scratch is removed. Use soft cloth and small amount of polishing compound to restore shine. Repeat as needed until surface shine is restored.
IMPORTANT!
DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and simmilar
solutions. Use of such solutions may cause corrosion, finish peeling, and/or
dull the surface.
DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes
that will permanently scratch the surface.
Retain these installation instructions for future reference!
Thank you for using WoodBridge products!
Please don’t hesitate to contact us if you have any questions or concerns.
Customer Service Phone: 562-229-0088.
(Monday – Friday 9 AM – 5 PM Pacific Time) Or Email:
help@woodbridgebath.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>