WOODBRIDGE F0008BG Freestanding Tub Filler Faucet with Hand Shower Installation Guide
- May 15, 2024
- WOODBRIDGE
Table of Contents
WOODBRIDGE F0008BG Freestanding Tub Filler Faucet with Hand Shower
Product Information
Specifications
- Max flow rate: 4.6 GMP at 80 PSI
- Max hand shower flow rate: 1.8 GPM AT 80 PSI
Product Usage Instructions
Preparation for Installation
Ensure to pull all dimensions of the actual model for installation and
measuring purposes. Measurements in inches are rounded to the nearest 1/8.
Parts & Components
- Body
- Screw
- Canopy
Tools Required for Installation
- Basin Wrench
- Adjustable Wrench
- Teflon Tape
- Silicone Sealant
- Screwdriver
Installation Instructions
- Put the base cover over the pipe.
- Screw the pipe to the base.
FAQs
-
Q: What should I do if I encounter leaks after installation?
A: Check all connections for leaks, tighten any loose fittings, and ensure the Aerator is properly secured. -
Q: Can I use a spanner to tighten the flexible hoses?
A: It is recommended to hand tighten the flexible hoses to avoid damaging the O-ring. Do not use a spanner for this purpose.
PARTS & COMPONENTS
TOOLS REQUIRED FOR INSTALLATION
PREPARATION FOR INSTALLATION
ATTENTION! Dimensions may vary by up to 3/8″. It is highly recommended to
pull all dimensions of actual model for installation and measuring purposes.
ATTENTION! Measurements in inches are rouned to the nearest 1/8″.
TECHNICAL DATA
- Max flow rate 4.6 GMP at 80 PSI
- Max hand shower flow rate 1.8 GPM AT 80 PSI
INSTALLATION INSTRUCTIONS
- Put the base cover over the pipe.
- Screw the pipe to the base.
- Install the flexible hose now and ensure the flexible hoses are hand-tightened into place.(DO NOT USE SPANNER TO TIGHTEN AS IT CAN DAMAGE THE O-RING). The flexible hoses are to be fitted into the correct inlets for hot water and for cold water.
- Fix the faucet body to the pipe.
- Fix the screw position
- Connect another side of the flexible hose to the water supply pipe. Make sure they are to be fitted into the correct outlets for hot water and cold water.
- Use the explosion screw to fix the base on the ground. and put the base cover over the base.
- Connect the shower hose and hand shower.
- The installation is completed.
- After installation is complete, remove Spray head and rotate handle to the close position. Turn Water Supply Valves on, and check all connections for leak. Flush faucet by running hot and cold water in full position for one minute. Re tighten the Aerator.
Customer Service
Phone: 562-229-0088. (Monday – Friday
9 AM – 5 PM Pacific Time)
Or Email: help@woodbridgebath.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>