WORLDWIDE 202-138BEG Brady Dining Chair Instruction Manual
- June 1, 2024
- Worldwide
Table of Contents
WORLDWIDE 202-138BEG Brady Dining Chair
- Thank you for purchasing this product. Please check to ensure that all parts are included.
- Contact the place of purchase for any service issues.
- Keep this document for reference in case parts are needed.
- THIS ITEM IS NOT RECOMMENDED FOR COMMERCIAL USE
IMPORTANT MUST READ BEFORE ASSEMBLY!
- FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY.
- PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE.
BASIC ASSEMBLY TECHNIQUES
- Before attaching each of the screws, make sure that the smaller lock washer is between the larger washer and the head of the screw.
- Position each part correctly and insert all screws into their respective holes.
- Then, hand-tighten only until 70% tight. Complete tightening with the tools will come at a later step.
- Make sure the furniture rests on a flat and level surface with each leg evenly touching the ground. Use a soft blanket or carpet underneath when turning the piece on its side.
- Some furniture comes with optional height adjustment knobs underneath each leg. Turn this knob counterclockwise to raise the leg level or dockwise to lower the leg level.
- Finally, make sure all parts are properly aligned then use the included tools to completely tighten the screws. Your furniture is now ready for use.
- Store the tools for later maintenance. Tighten the screws again after two (2) weeks, and then at least once every six (6) months after that.
- IT IS THE USER’S RESPONSIBILITY TO MAINTAIN THE FURNITURE. THE SCREWS MAY LOOSEN OVER TIME AND CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY.
- THIS CAN LEAD TO COLLAPSE AND CAN CAUSE SERIOUS INJURY.
- FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE.
ASSEMBLY INSTRUCTIONS
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>