WORLDWIDE HOMEFURNISHINGS 202-139MS Talton Dining Chair Instruction Manual

WORLDWIDE HOMEFURNISHINGS 202-139MS Talton Dining Chair

Product Information

Specifications

• Model Numbers: 202-139MS, 202-139CAM, 202-139CH
• Hardware: M6x16 screws x4, M6 screws x4, M5 screws x1

Product Usage Instructions

Assembly Steps

1. Step 1:
2. Secure the rotated plate using four M6x16 screws.
3. Attach part D into the designated hole to lock it in place.
4. Step 2:
5. Fasten four M6 screws and one M5 screw.
6. Step 3:
7. Arrange parts A, B, C, and D as directed.
8. Rotate the plate by 45 degrees and insert part D into the hole to secure it.
9. After tightening the screws, remove part D if necessary.

FAQ

• Q: How do I know which model number to use?
• A: Refer to the label on your product or contact customer support for assistance.
• Q: Can I use different-sized screws for assembly?
• A: It is recommended to use the specified hardware for optimal assembly and performance.

Thank you for purchasing this product. Please check to ensure that all parts are included. Contact the place of purchase for any service issues.

• Keep this document for reference in case parts are needed.
• THIS ITEM IS NOT RECOMMENDED FOR COMMERCIAL USE

IMPORTANT
MUST READ BEFORE ASSEMBLY!

• FOR YOUR FURNITURE TO LAST, CORRECT ASSEMBLY AND PROPER MAINTENANCE ARE NECESSARY.
• PLEASE FOLLOW THE INFORMATION PROVIDED BELOW TO FULLY ENJOY YOUR FURNITURE.

BASIC ASSEMBLY TECHNIQUES

1. Before attaching each of the screws, make sure that the smaller lock washer is between the larger washer and the head of the screw.
2. Position each part correctly and insert all screws into their respective holes. Then, hand-tighten only until 70% tight. Complete tightening with the tools will come at a later step.
3. Make sure the furniture rests on a flat and level surface with each leg evenly touching the ground. Use a soft blanket or carpet underneath when turning the piece on its side.
4. Some furniture comes with optional height adjustment knobs underneath each leg. Turn this knob counterclockwise to raise the leg level or dockwise to lower the leg level.
5. Finally, make sure all parts are properly aligned then use the included tools to completely tighten the screws. Your furniture is now ready for use.
6. Store the tools for later maintenance. Tighten the screws again after two (2) weeks, and then at least once every six (6) months after that

• IT IS THE USER’S RESPONSIBILITY TO MAINTAIN THE FURNITURE. THE SCREWS MAY LOOSEN OVER TIME AND CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS CAN LEAD TO COLLAPSE AND CAN CAUSE SERIOUS INJURY.
• FAILURE TO FOLLOW THE GUIDELINES ABOVE MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE.

PARTS AND TOOLS

• 202-139MS/202-139CAM/202-139CH

ASSEMBLY INSTRUCTION

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>