FRONTIER 008946741 Wood Worktop Steel Frame Workbench Instruction Manual
- June 1, 2024
- FRONTIER
Table of Contents
FRONTIER 008946741 Wood Worktop Steel Frame Workbench
Specifications
- Adjustable leg with power charge strip
- Rubber wood top
- Rod holder
- Comes with necessary screws and bolts
Product Usage Instructions
Components Check:
Ensure all components are present before assembly. Do not proceed if any parts are missing. Contact the seller if needed.
Tools Required:
- PH2 Screwdriver
- 13mm Spanner
- 19mm Spanner
- 5mm Hex Key
Assembly Steps
Step 1:
Fix the adjustable leg (A)(B) with beam (C) using 8 pcs of M8 x 20 (BB) bolts.
Step 2:
Place the rubber wood top (D) on a flat surface with the positioning label facing up. Install the legs (A&B) & beams (C) on the top using M5 x 15 screws (AA).
Step 3:
Fix the support rod (E) on the shaft of the rubber wood top (D) using M5 x 15 screws (AA).
Step 4:
Stand up the workbench and adjust the feet if necessary to ensure stability.
Disposal Information:
Please recycle where facilities exist. Check with your local authority for recycling advice.
Customer Service:
If you need support or have difficulty using the product, please contact the seller.
Frequently Asked Questions
Q: What should I do if some parts are missing?
A: Contact the seller immediately to resolve the issue and get the missing parts.
Q: Can I tighten all screws before the final step?
A: It is recommended not to tighten all screws before the final step to ensure proper alignment.
Q: How do I make sure the workbench is stable?
A: Stand up the workbench and adjust the feet if necessary to make it stable.
008946741
CAUTION:
Read and follow all Safety Rules and Operating instructions before
Notice: Picture shown is for illustration purpose only and may differ from the
actual product.
NOTE: If any parts are missing or damaged, or if you have any questions, please contact the seller.
COMPONENTS
Ensure all components are present. If any components are missing, do not proceed with assembly. Please contact the seller.
ASSEMBLY
NOTE: Do not tight all the screws before final step.
Step 1
Fix the leg (A)(B) with beam (C) use 8 pcs M8 x 20 (BB).
Step 2
- Place the rubber table top (D) on a flat surface with the positioning label facing up.Protect the table with packaging materies.
- Align the positioning label and install the legs (A&B) & beams (C) on the rubber wood top using M5 x 15 cross head tapping screw(AA).
Step 3
Fix the support rod (E) on the shaft of the rubber wood top (D) using M5 x 15 cross head tapping screw(AA).
Step 4
Stand up the workbench and adjust the feet if necessary to make the workbench stable.
DISPOSAL INFORMATION
Please recycle where facilities exist. Check with your local authority for recycling advice.
CUSTOMER SERVICE
If you are having difficultly using this product and require support. Please
contact the seller.
Retain this manual for future use.