DORMAN 917-136 Oil Distributor Seal Kit Instruction Manual

June 1, 2024
DORMAN

DORMAN 917-136 Oil Distributor Seal Kit

DORMAN 917-136 Oil Distributor Seal Kit

Important Information

ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully. This product is only designed to function properly on specific vehicle applications. Please verify that the vehicle requirements match the product specifications and application notes for this part.

REMOVAL/INSTALL OF OIL DISTRIBUTOR SEAL KIT (917-136)
Acura 1999–97, Honda 2002–75 

GENERAL TECH TIP

  • There are two different size seals used in Honda distributors. This kit contains both sizes. Be sure to select the one that fits tightly into distributor housing.

PLEASE WEAR SAFETY GLASSES!

Instructions

STEP 1: Remove distributor from engine. Consult service manual for removal procedure of distributor.
STEP 2: Remove distributor cap and ignition rotor.
STEP 3: Using an awl or similar tool make scribe marks on drive flange and shaft to maintain original orientation prior to removal.

Instructions

STEP 4: Remove drive flange retaining snap ring.

Instructions

STEP 5: Slide out drive flange retaining pin. Remove flange and thrust washers.

Instructions

STEP 6: Remove ignition coil if equipped with internally mounted coil. Proceed to Step 7 if you have an externally mounted coil.
STEP 7: Remove shaft and stator plate assembly. Be sure to make scribe marks on the plate and housing before loosening mounting screws to maintain factory orientation.

Instructions

STEP 8: Remove seal by using a screwdriver or suitable tool to push seal out from bottom side of distributor.

Instructions

STEP 9: Lubricate new seal with a thin coat of grease to ease installation and prevent damage to seal during installation.
STEP 10: Drive in new seal using a seal driver or a socket 1mm smaller in diameter than outside diameter of seal.

Instructions

STEP 11: Reinstall stator and plate, be sure to align scribe marks placed on plate and housing.
STEP 12: Reinstall thrust washers, drive flange, drive flange pin, and snap ring. Align scribe marks-placed on flange and shaft in step 3 prior to sliding drive flange onto shaft.
STEP 13: Reinstall distributor onto engine.

Still need help?

Please call our Technical Support team for assistance from our team of certified automotive experts.
1-800-523-2492

Disclaimer

Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.

Dorman Products, Inc. | Corporate Office and Customer Service: 1-800-523-2492
©2021 No reproduction in whole or in part without prior written approval.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals