DORMAN 926-063 Lgnition Lock Cylinder Installation Guide
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 926-063 Lgnition Lock Cylinder Installation Guide
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
REMOVAL/INSTALL OF IGNITION LOCK CYLINDER (926-063)
Chevrolet 1997–95, GMC 1997–95
PLEASE WEAR SAFETY GLASSES!
Removal Instructions
STEP 1: Disconnect negative battery cable.
STEP 2: Remove column tilt lever by pulling straight out, if equipped.
STEP 3: Remove column lower cover by removing mounting screws.
STEP 4: Remove upper column cover by removing retaining screw and lifting
off of column.
STEP 5: Remove ignition lock cylinder by rotating to start position.
While holding ignition in start position, insert small screwdriver or pick
into release hole and pull lock from column.
Installation Instructions
STEP 1: Install ignition lock cylinder. If lock will not seat into
housing use a screwdriver to align internal mechanism with new lock cylinder.
STEP 2: Reinstall steering column upper trim cover and screw.
STEP 3: Reinstall lower steering column trim cover and retaining screws.
STEP 4: Reinstall tilt lever if equipped.
STEP 5: Reconnect negative battery cable and verify proper operation of
ignition lock.
We appreciate your opinions regarding this product!
Please call our Technical Assistant with any challenges or suggestions
regarding the installation or operation of this product.
1-800-523-2492
Disclaimer:
Even though every attempt is made to ensure this information is complete and
accurate, it is impossible to account for all possible circumstances or
situations. Please consult with a qualified auto technician
before attempting to perform any work you are not qualified to do. Automobiles
can be hazardous to work on; be sure to take all necessary safety precautions.
Failure to do so may result in property damage or personal injury. Certain
motor vehicle standards and performance requirements may apply to your motor
vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Traffic Safety Administration). Be sure that your work is performed in
accordance with such standards and that you do not disable any motor vehicle
safety feature.
©2018 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>