DORMAN 600-901 Transfer Case Motor Instruction Manual
- June 1, 2024
- DORMAN
Table of Contents
DORMAN 600-901 Transfer Case Motor Instruction Manual
Description:
DTC-C0308 will be set when the Transfer Case Control Module (TCCM) determines a short to ground in motor control circuit A or B.
What causes DTC-C0308:
DTC-C0308 will set when the Transfer Case Control Module detects a variation in supply voltage going to both the Motor Control Circuit A or B. DTC-C0308 will also activate if the feedback voltage is excessively low on Motor Control Circuits A or B. Once DTC-C0308 has been activated, all of the 4WD shifter will be inoperative and will cause the “SERVICE 4WD” light to turn on.
How to access the diagnostic trouble code (DTC):
Once there has been a DTC set, the vehicle will either set a “Service 4WD”
light, or the lights on the 4×4 switch will fl ash and/or stay lit. To access
the DTCs, you will need to hook up a vehicle diagnostic scanner utilizing the
service port under the driver side portion of the dash.
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
When to clear a DTC:
The diagnostic trouble code (DTC) should only be erased once the voltage concern has been corrected, or the mechanical problem has been addressed.
How to clear a DTC:
- The Transfer Case Control Module (TCCM) will clear the DTC once the initial problem has been fixed.
- A hard DTC will clear once the vehicle has run through one hundred (100) start cycles and detects no faults.
- To clear the DTC manually, you will need a vehicle diagnostic scanner (Scan tool). Once the DTC has been erased, go back into the vehicle system and verify that the DTC has been erased and that the system is performing properly.
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi c Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
©2012 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>