PEGASUS ASTRO 58653 Pocket Powerbox User Guide
- June 6, 2024
- PEGASUS ASTRO
Table of Contents
QUICK INSTALLATION GUIDE
Thank you for choosing our products
Pocket Powerbox (in short PPB) is suitable for the “grab and go” astronomer/photographer. The device can provide 10 Amps of electric power, has four 12V outputs, two dew heater channels, an 8V DSLR /Mirrorless Camera power output, and an environmental sensor to constantly monitor humidity and ambient temperature. A controller can adjust the dew heaters consulting the sensor temperature/humidity values and calculating the dew point of the environment.
Operating Instructions:
- Plug the external environmental sensor, the 12V DC power cables, and the USB cable into the device.
- Plug the power supply (battery or power pack) into the DC 2.1mm socket. We strongly advise using a power supply that can provide DC 12V -13.8V and > 5 Amps.
- Device will boot after three seconds and the red indicator LED will blink three times. This means that firmware was loaded successfully and the “Pocket Powerbox” is now fully operational.
- Default settings provide DC pass-through voltage to all four outputs. Dew Heater outputs are switched off after boot. DSLR Camera Output is switched on by default.
- Download USB drivers, standalone software, or ASCOM drivers from pegasusastro.com/support in order to connect to the device.
Place the “Pocket Powerbox” on the dovetail of your telescope/mount. We strongly recommend following this kind of approach and having the device near your telescope. Power cable length is adequate to connect all of your equipment to the powerbox.
WARNING: DO NOT use a 12v port to power USB hubs, unless the hub can accept 12v input. Most powered USB hubs are 5v and 12v can damage the hub and any cameras or accessories attached to the hub. Always read hub instructions before connecting.
Portability Hint: Pick up your favorite mini PC or PC Stick and USB Hub and place it close to the “Pocket Powerbox”.
What is in the box:
- 1 x Pocket Powerbox
- 1 x DC Cable (2.1m) to Cigarette Lighter (8A fused)
- 4 x Power Cables (1 meter)
- 1 x USB2 Cable Type B (1.8 meters)
- 1 x Environmental (Humidity/Temperature) Sensor
Optional Accessories:
- Power cable for Skywatcher EQ8
- Power cable for Skywatcher EQ6R / EQ6-AZ
- Battery Couplers for Canon DSLR, Nikon DSLR, Fuji X Series, Sony A7
http://pegasusastro.com/wp-content/uploads/2019/07/PPB_manual_v1.2.pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>