PremiumSpec Color Selectable Linear Lights Instruction Manual

: September 21, 2024
: PremiumSpec

Table of Contents

PremiumSpec Color Selectable Linear Lights
Power Feed
Parts List
Non Power Suspension
Wiring Diagrams
MORE INFORMATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PremiumSpec Color Selectable Linear Lights

WARNING

Installation, service, and maintenance of luminaries should be performed by a qualified licensed electrician.
To reduce the risk of fire and overheating, make sure all connections are tight.
Once the final building cleanup has been completed, remove the protective film on the lens.

CAUTION

Do not install in wet locations. For dry and damp use only.
Do not cover the fixture with heat insulation gaskets or similar materials.

Power Feed

Parts List

4″ Octagonal Junction Box (by others)
Electrical Wiring (by others)
Wire Nut
Junction Box Crossbar
Screw PM4*22
Power Cord
4″ Power Canopy Kit
Cable Holder
Strain Relief Thread Nut
Aircraft Cable
Drywall Ceiling (by others)
Butterfly Drywall anchor
Crimp Stud
2″ Canopy
Solid Ceiling (by others)
Anchor
Screw PA4*30

Non Power Suspension

Pendant Installation Instructions

Screw aircraft cables clockwise on the top luminaire.
Connect the quick connectors.
Zip tie power cord & aircraft suspension cable with the cable tie if needed.

The height of the luminaire can be adjusted with the aircraft cable gripper. Raise the luminaire by pulling the cables through the gripper. Lower the luminaire by pressing the top cylinder on the gripper, and carefully pull the luminaire down.

Wiring Diagrams

WARNING

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
Proper grounding is required to ensure safety.
Power must be turned off at the breaker before installation or maintenance.
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.