aspire AVP-CUBE Electronic Cigarette Complete Kit User Manual

aspire AVP-CUBE Electronic Cigarette Complete Kit

SAFETY INFORMATION

For a safe and effective use of this product and its accessories, we advise you to read the following instructions in full, and to strictly observe the operating procedures indicated in this manual and refer to the leaflet contained in the packaging of the individual products/ accessories. This product is intended for adult smokers.
This product is not recommended for non-smokers, young people under the legal age, pregnant or breast feeding women and those experiencing general ill health.
Keep the product and its accessories out of reach of children and minors at all times!

COMPONENTS OF THE PRODUCT

This product is a high-tech product and its components such as the battery, the Type-C cable, and the pod part have been specifically made for this product. We recommend the exclusive use of components and accessories indicated. Use of components and / or accessories not specifically produced for this device may lead to a malfunction and/ or damage to the product and to the cancellation of the warranty.

WARNINGS BEFORE USE

The use of an empty, dry or drained tank/pod can cause immediate damage to the internal resistance and the consequent cancellation of the warranty.

GENERAL WARNINGS AND LIMITATIONS OF USE

Do not bring your vape device into contact with water or other e-liquid. Avoid exposing the device to too low or too high temperatures (-5° C / 50 ° C). Avoid using the product in overheated or excessively damp environments. Keep the product and its accessories away from heat sources. Use only Aspire original spare parts and accessories. Always discharge the battery completely before recharging. Carefully read the composition of thee-liquid before use, and do not use the product if you are allergic to any of the components of thee-liquid. Do not use the product if you suffer from respiratory and/ or cardiovascular system disorders. Do not use the product during pregnancy or lactation.
Do not ingest or swallow any part of the product or its accessories and do not try to open or tamper with the components of the product or its accessories. The device does not need any flame to light it. To avoid performance losses, disconnect the battery from the USB charger when fully recharged, and in the case of anomalies, smell of burnt or abnormal deformation of one of the components of the device or its accessories, stop using it immediately and contact Customer Care.
Avoid direct contact of thee-liquid with the mouth which could happen if you inhale too strong and too frequently or if the tank is too full.
Avoid any unauthorized operations that may damage the product. For an optimal performance of your vape device, it would be advisable to spend at least 30 seconds between one inhalation and the next. We recommend only to use the Aspire charger to charge this device and not attempt to recharge the device with any other type of charger. We don’t recommend using the product while charging.
Do not discard this product in the environment, and dispose of the product components at dedicated collection/disposal points.

SAFETY NOTE

To avoid misfiring always ensure you either lock or switch off your device when it is not in use. Especially when carrying your device in your pocket, bag or purse.

CONTENTS

1 AVP-CUBE Device (1300 mAh)
1 AVP-CUBE Pod (3.5 ml)
1 AVP Pro Standard Coil 1.150
1 AVP Pro Mesh Coil 0.650
1 Type-C Cable
1 User Manual

COMPONENTS VIEW

SPECIFICATIONS

Pod capacity: 3.5 ml
Built-in battery capacity: 1300 mAh
Dimensions: 1102222 mm
Adjustable airflow
Coil parameters:
0.650 15-18W Canthal AF(Mesh coil)
1.150 10-16W Canthal AF
Easy bottom fill

Output mode:

1. Bypass output (when the resistance is less than 1.00)
2. Optional output wattage: 10 W, 12 W, 14 W, 16 W (when the resistance is equal or higher than 1.00)

• When using a new coil, let the pod sit for 5 minutes after filling  so the cotton can be saturated with-liquid before use.
• Do not let the pod become completely empty. Refill the pod to avoid dry burning or damage to the coil.

COIL INSTALLATION

• Detach the pod
  

• Replace the used coil with a new coil

• Insert the pod back

POD FILLING

• Detach the pod
  

• Lift the silicon seal and add e-liquid through the filling hole

• Insert the pod back

HOW TO ADJUSTTHE AIRFLOW

To adjust the airflow, detach the pod and align the airflow channel with each of the four sides of the mod. Each side will activate a different airflow level.

INSTRUCTIONS

times; When the resistance < 1.00, the light will flash sequentially green, blue, and then red.
Click the fire button 5 times quickly to turn the device on or off| It flashes white 3 times
Battery level > 3.8V (60-100%)| Green
Battery level = 3.5~ 3.8V (30-60%)| Blue
Battery level < 3.SV (0-30%)| Red
Quickly press the fire button twice to set the output wattage| The light will flash in different colors 3 times to indicate the level of output wattage:
Flashing white is 16W
Flashing green is 14W
Flashing blue is 12W
Flashing red is 10W

Note: The output wattage can only be selected when the resistance of the connected coil is detected to be equal or higher than 1.00; when the coil’s resistance is less than 1.00, the output mode is automatically in bypass mode therefore cannot be adjusted. If you press the mode button twice, the LED light will flash sequentially red, blue, and green to indicate that the output wattage cannot be adjusted.

PROTECTIVE FEATURES

device will cut off

CHARGING INSTRUCTIONS

IMPORTANT INFORMATION ABOUT USING NICOTINE CONTAINING

E-LIQUIDS
Before using nicotine containing e-liquid the user should read the following information carefully.

NICOTINE CONTAINING E-LIQUID:
Do not use if you are allergic to nicotine or any of the other ingredients contained within thee-liquid (see manufacturer’s label for full details).

WARNINGS AND PRECAUTIONS

Nicotine containing e-liquid are not recommended for:

• Non-smokers
• Young people under the legal age;
• Pregnant or breast-feeding women; as nicotine is known to cross the placenta and to be excreted in breast milk;
• Those experiencing general ill health; such as heart disease, stomach and duodenal ulcers, liver or kidney problems, long term throat disease or difficulty breathing due to bronchitis, emphysema or asthma;
• Those who have an overactive thyroid gland or have a pheochromocytoma (a tumor of the adrenal gland that can affect high blood pressure);
• Those who have diabetes, as nicotine may affect your blood sugar levels.
• Those taking the following medication;
• Theophylline (to treat breathing problems)
• Ropinirole (to treat restless leg syndrome)
• Clozapine (to treat schizophrenia)

POSSIBLE SIDE EFFECTS

If you inhale too much nicotine or use the product too much you may experience one or more of the following effects:

• Feeling faint;
• Nausea (feeling sick)
• Headache
• Coughing
• Irritation of the mouth or throat
• Dizziness
• Stomach discomfort
• Hiccups
• Nasal congestion
• Vomiting (being sick)
• Heart palpitations
• Abnormal heart rate

If you experience any of these side effects; including any possible side effects not listed in this leaflet, discontinue using the product, if the effect(s) continue after you stop use, consult your doctor or healthcare professional and bring this leaflet to their attention.

WARRANTY

Please visit below our official website to know our warranty policy and find an official after-sale support center in your country: https://www.aspirecig.com/service/

If your region doesn’t have a support center, you can contact the retailer for service as normal.

Important Information:
When requesting for warranty claims, kindly provide receipts or invoice purchased from vendor. Please also keep the original box containing the serial number and security code, or batch code for verification.

For detailed operating instructions, please visit:
Manual: https://www.aspirecig.com/downloads/manuals/
Video: https://www.youtube.com/c/Aspirecigs

CUSTOMER SUPPORT

Shenzhen Eigate Technology Co., Ltd.
Floor 1-4, Building 3, No.14 Jian’an Road, Shajing Sub-district, Bao’an District, Shenzhen, Guangdong Province, China
Tel: +86-755-81499783
Email: service@aspirecig.com

To learn more about our products and how to use, please visit:
www.asp1rec1g.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>