HD Ridez WB-TD298BD Steel Construction Drop Down Style Running Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-TD298BD Steel Construction Drop Down Style Running Boards Installation Guide
PARTS LIST:
PROCEDURE:
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS HIGHLY RECOMMENDED.
- Starting on the Passenger/Right side of the vehicle and remove the plastic plugs or hex bolts from the factory mounting location along the bottom of the body, ( Figures 1 & 4).
- Select the Passenger/Right Front Mounting Bracket. Attach the Bracket to the front location with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, ( Figures 2 & 3). Do not tighten hardware.
- Repeat Steps 2 & 3 to attach the (3) Rear Mounting Brackets, ( Figures 4 & 5).
- Select the Passenger/Right DS4 Running Board. Attach the (4) mounting tabs on the Running Board to the rear faces of the (4) Mounting brackets with (8) 10mm Hex Bolts, (16) 10mm Flat Washers and (8) 10mm Nylon lock Nuts, ( Figure 6 ).
- Level and adjust the Running Board and tighten all hardware.
- Repeat Steps 2–6 to attach the Driver/Left DS4 Running Board.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Use only mild soap to clean the Running Boards.
Passenger/Right Side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>