PELONIS PHT20A2ABGUK 16 Inch PTC Ceramic Heater User Manual
- June 1, 2024
- Pelonis
Table of Contents
PELONIS PHT20A2ABGUK 16 Inch PTC Ceramic
Heater
Product Specifications
- Product Name: 16 Inch PTC Ceramic Heater
- Model: PHT20A2ABGUK
- Power Supply: 220-240V AC
Safety Instructions
- Do not cover the heater to avoid overheating.
- Replace the damaged supply cord with a qualified person.
- Children aged 8 and above can use it under supervision.
- Do not place the heater immediately below a socket outlet.
- Avoid using the heater near baths, showers, or swimming pools.
- Keep children under 3 years away unless continuously supervised.
Operating Instructions
- Check the power wire condition before use.
- Ensure the power socket meets local requirements with safe grounding.
SAFETY INSTRUCTION
-
Warning: In order to avoid overheating, do not cover the heater.
-
If the supply cord is damaged, it must be replaced by the manufacturer its service agent or a similarly qualified person in order to avoid a hazard.
-
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be done by children without supervision.
-
The heater must not be located immediately below a socket outlet.
-
Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
-
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance. -
CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
-
Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collec-tion systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling. -
Do not use this heater if it has been dropped.
-
Do not use it if there are visible signs of damage to the heater.
-
Use this heater on a horizontal and stable surface.
-
WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own unless constant supervision is provided.
-
WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material at a minimum distance of 1 m from the air outlet.
-
Details concerning precautions during user maintenance.
-
Consider all the information, including the information contained in the “CLEANING AND MAINTENANCE INSTRUCTION” chapter.
-
Household use only.
PART FIGURE
OPERATING INSTRUCTION
Check before turning on the machine
- Check if the power wire is in good condition.
- The product adopts a 220-240V AC power supply, before use, please confirm if the rated current of the power socket meets the local requirements with a safe grounding device, otherwise, please replace it with the qualified socket.
Put the machine on the flat place
The uneven place may possibly cause the turnover to switch at an abnormal
position, then the heater can’t work after turning on, therefore, please put
the heater on the flat place, at least the surface below the base of the
heater must be flat.
Temperature Control Knob
Insert the plug into the power socket, then turn the Temperature Control knob
clockwise, when hearing the “poop” sound (it means the temperature controller
is on), adjust the Temperature Control knob to the desired temperature level.
Power Selection Knob
Turn the Power selection knob to select between 4 functions: Low 1200W(LOW),
High 2000W(HIGH), Low 1200W Swing (LOW SWING), High 2000W Swing (HIGH SWING).
Turn off the Heater
- A. Turn the Power selection knob to OFF position.
- B. Turn the Temperature Control knob anticlockwise to the initial position.
- C. Remove the power plug, store the heater after the entire machine has become cool.
Safety Protection
- A. Overheating protection device: when the working environment is abnormal or the operation is incorrect which causes high temperature in the heater, the temperature control component will automatically cut off the power supply and stop working; after the entire machine has become cool and the fault has been removed, it may recover to normal use.
- B. Tip-over safety protection device: When the machine is turned over, the safety system will automatically cut off the power supply, after uprear the machine, the heater may recover to the working status.
- C. Anti-frost function: When the machine is on, turn the Temperature
Control knob to the “MIN” position, and whenever the room temperature drops to0-5ºC, the heater will automatically turn on. When the room temperature is over 5ºC, the fan heater will automatically turn off.
SAFETY CONTROL
Your heater is fitted with a safety device “Double Protector” that (1)
switches off the heater by a thermal cut-off in the event of overheating or
malfunction, It will reset while the temperature reduces to a normal level.
(2) Shuts off the heater by thermal fuse in the event of overheating or
malfunction and not operating for some other accidental reason.
If overheating or malfunctions continue, return the heater to an Approved
Service Agent for examination.
The most common cause of overheating is deposits of dust or fluff entering the
heater, Ensure these deposits are removed regularly by unplugging the unit and
vacuum-cleaning air vents and front grille.
PILOT LIGHT
This fan heater is equipped with a pilot light that glows whenever the heater is plugged in and turned on. It will continue to glow even if the thermostat has cycled the heating elements off. This feature is to prevent you from being unaware that the heater is operating and maintaining the temperature of the room. When you do not wish the heater to control the room temperature, turn the control switch to O (off) and remove the plug from the electrical outlet.
CLEANING AND MAINTENANCE INSTRUCTION
- Light-accumulated dust may be removed from the heater with a soft cloth. Wipe the exterior surfaces of the heater occasionally with a cloth moistened (not dripping wet) with a solution of mild detergent and water. Dry the case thoroughly with a soft dry cloth before operat-ing the heater.
- The fan motor is lubricated by the factory and will require no further lubrication.
- No other user maintenance is required or recommended. If service is required, send your heater to the nearest authorized service depot.
- Store the heater in a clean and dry place when not in use.
REMEMBER – portable electric heaters are designed for spot heating, or as
a supplementary heat source. They are not intended to be the main sources of
heat during the normal heating season.
Note: There may be a trace of smoke or odour when the unit is first
operated. Do not be on the heating coil during the manufacturing process. It
will quickly evaporate, and should not re-occur.
Contact us
E-mail：cs_eu@pelonis.com
Company TC Kangbridge Ltd
Address:TC Lumionous house,300South row,Milton keynes,MK9 2FR
Tel/Mobile:+44(0)7908917780
E-mail:epr@tangcheng.top
FAQ
Q: Can children under 3 years old use the heater?
A: Children under 3 years should be kept away unless continuously supervised.
Q: What to do if the supply cord is damaged?
A: The damaged cord must be replaced by a qualified person to avoid hazards.
Q: What should be the minimum distance from flammable materials?
A: Keep textiles, curtains, or any flammable material at a minimum distance of 1m from the air outlet to reduce the risk of fire.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>