PELONIS PH-19J PTC Ceramic Heater Owner’s Manual
- May 15, 2024
- Pelonis
Table of Contents
PH-19J PTC Ceramic Heater
Owner’s Manual
PTC
CERAMIC HEATER
OWNER’S MANUAL
MODEL: PH-19J/PTH15A2BGB
PH-19J PTC Ceramic Heater
PLEASE READ AND SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed
to reduce the risk of fire, electric shock, and injury to persons, including
the following:
- Read all instructions before using this heater.
- This heater s hot when n use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater s left operating and unattended.
- Always unplug heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
- Do not use outdoors.
- This heater s not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate heater where it may fall into bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- To disconnect heater, first turn controls to off, then remove plug from outlet.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust n any manner. Do not use on soft surfaces, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it n the areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described n this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- CAUTION: Always plug heaters directly not a wall outleT receptacle. Never use with an extension cord or relocatable power tap (outleT power strip).
- This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
- It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
- The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an nobility to react to avoid burns.
- Don’t leave the heater unattended.
- “SAVE THESE INSTRUCTIONS”
OPERATION INSTRUCTIONS
IMPORTANT!
Your heater is equipped with a polarized alternating current line plug a plug
having one blade wider than the other). This plug will fit into the power
outlet only one way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug. If the plug still fails
to fit, contact your electrician to replace your outlet. DO NOT defeat the
safety purpose of the polarized plug. 
Control Panel Functions
A Power and Setting Control
B Power Indicator Light
C Thermostat Control
-
Place the heater on a firm level surface that is free of obstructions, and at least 3 ft. (0.9m) away from all walls and other objects such as furniture, curtains, plants or combustible material.
-
With the Power and Setting Control “A” in the “OFF” position, plug the heater into a grounded 120V outlet.
-
Turn the heater “ON” by turning the Power and Setting Control “A” clockwise to the desired power setting (LOW, HIGH, LOW & OSC or HIGH & OSC). The Power Indicator Light “B” will illuminate. The power settings operate as follows:
LOW: The Fan and heating elements operate at LOW setting operates at 900W.
HIGH: The Fan and heating elements operate at HIGHT setting operates at 1500W.
LOW&OSC: The Fan and heating elements operate at LOW setting with oscillation.
HIGH& OSC: The Fan and heating elements operate at HIGHT setting with oscillation. -
Turn the Thermostat Control “C” to the desired setting between “MIN” and “MAX.”
Note: This heater includes a safety tip-over switch, which will shut the heater off in case it is tipped over. If at any time, the heater does tip over, please put the heater back in the upright position. The heater will resume its normal operation.
CAUTION:
This heater includes a thermal cut-off that shuts the heater off if it
overheats due to abnormal conditions. If this occurs, turn the heater “OFF”,
unplug it, and inspect and remove any objects on or adjacent to the heater.
Allow it to cool for a few minutes, and then plug it back in and resume normal
operation.
TROUBLESHOOTING
If your heater fails to operate, please follow these instructions:
- Ensure that your circuit breaker or fuse is working properly.
- Be sure the heater is plugged in and that the electrical outlet is working properly.
- Check for any obstruction. If you find an obstruction, turn the heater “OFF.” Unplug the heater and wait a few minutes for it to cool down. Carefully remove the obstruction. Plug the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER, PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF. DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY. IF THE PROBLEM STILL PERSISTS, PLEASE CONTACT US BY REFERRING TO THE SERVICE & SUPPORT INFORMATION ON THE FOLLOWING PAGE.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off-season storage
- Turn the heater “OFF,” unplug it and wait for the heater to cool down.
- Use a dry cloth to clean only external surfaces of the heater.
- Do not use any cleaning agents or detergents.
- Never immerse the heater in water.
- Pack the heater in the original carton and store it in a cool and dry place.
SPECIFICATIONS
Model No.: PTH15A2BGB
Voltage: 120V~, 60Hz
Current: Maximum continuous draw: 12.5 Amps
Output: 5200 BTUs
Power: LOW=900 Watts, HIGH=1500 Watts Tolerances on all
specifications:Approximately +5%
SERVICE & SUPPORT
In the event of a warranty claim or if service is required for this heater,
please contact us at the following:
Toll Free: 1-866-646-4332
Email us at: customersupport@pelonis.com
For questions or comments, please write to:
Midea America Corporation
Customer Care Center
5 Sylvan Way, Suite 100
Parsippany, NJ 07054
For your records, staple your sales receipt to this manual and record the
following:
DATE OF PURCHASE: _
PlACE OF PURCHASE: _
ISTAPLE SALES RECEIPT HEREI
NOTE: PROOF OF PURCHASE IS REQUIRED FOR All WARRANTY CLAIMS PRINTED IN CHINA
ONE (1) YEAR LIMITED WARRANTY
• Please read all instructions before attempting to use this product.
PELONIS warrants as limited herein to the original purchaser of retail that
each new Pelonis Ceramic Tower Heater, shall be free of defects in material
and workmanship for a period of one (1) year from the date of original
purchase. This one (1) year warranty is limited to the heating elements,
motor, and electric control circuit board.
In the event of malfunctions or failure of your Pelonis Ceramic Tower Heater,
simply deliver or send the heater, postage prepaid along with PROOF OF
PURCHASE, within the warranty period of one (1) year, to PELONIS. PELONIS
reserves the right to inspect the claimed defective part or parts to determine
if the defect or malfunction complaint is covered by this warranty. PELONIS
shall, within sixty (60) days after receipt of the product, at its option,
repair and/or replace the defective part or parts free of charge. This
warranty shall only cover defects arising from normal usage. PELONIS assumes
no responsibility whatsoever if the Ceramic Tower Heater should fail during
the warranty period by reason of:
- Misuse, negligence, physical damage or accidents.
- Lack of maintenance (see instructions for proper maintenance).
- Repair by any unauthorized party during the warranty period.
- Damage caused by connection to an improper input voltage (see specification label on your heater).
PELONIS makes no further warranties or representations, express or implied
except those contained herein. No representative or dealer is authorized to
assume any other liability regarding the Ceramic Tower Heater. The duration of
the implied warranty granted under State law, including warranties of
merchantability and fitness for particular purpose are limited in duration
should the duration of the express warranty grant it hereunder. PELONIS shall
in no event be liable for direct, indirect, special or consequential damages.
Some states do not allow limitations on how long an implied warranty lasts,
and/or the above limitations or exclusion may not apply to you. This warranty
gives you specific legal rights and you may have other rights which vary from
state to state.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>