PELONIS NTH15-18MR Digital Tower Ceramic Heater Owner’s Manual
- June 4, 2024
- Pelonis
Table of Contents
PELONIS NTH15-18MR Digital Tower Ceramic Heater Owner’s Manual
IMPORTANT INSTRUCTIONS
PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances,basic precautions should always be followed to reduce the risk of fire,electric shock,and injury to persons, including the following:
- Read all instructions before using heater.
- This heater is hot when in use. To avoid burns, do not let bare skin touch hot surface. If provided, always use handles when moving this heater. Keep combustible materials such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and rear.
- Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
- Always unplug the heater when not in use.
- Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged in any manner. Discard heater or return heater to authorized service facility for examination, electrical or mechanical adjustment, or repair.
- Do not use the heater outdoors.
- This heater is not intended for use in bathroom, laundry areas and similar moist indoor locations. Never locate heater where it may fall into a bathtub or other water container.
- Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
- CAUTION: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. To do so could result in an electric shock hazard.
- This heater draws 12.5 amps during operation. To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working.
- CAUTION: It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
- To disconnect the heater, first turn controls to off, then remove plug from outlet. Never pull by the cord.
- Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater.
- To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surface, like a bed, where openings may become blocked.
- A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored.
- Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock, or injury to persons.
- CAUTION: Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or reloadable power tap (outlet/power strip).
- The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
- CAUTION: To prevent electric shock, match wide blade of plug to wide slot and fully insert.
“SAVE THESE INSTRUCTIONS”
PART FIGURE
OPERATING INSTRUCTION
Check before turning on the machine
- Check if the power wire is under good condition.
- The product adopts 120V AC power supply, before use, please confirm if the rated current of the power socket meets the local requirements with safe grounding device, otherwise, please replace it with the qualified socket.
Start the machine
Plug the unit into a grounded 120V outlet, the power light ” “on , press the
ON/OFF key (or press the ON/OFF key of the remote controller) for start, the
machine supplies air at high power after start, the digital screen displays
“HI”.
Function setting
Repeatedly press the “Function” key so that the heater switches in the order
of “high gear – low gear – ECO mode – high gear”.
Temperature setting
In the ECO mode of the machine, press “+” or “-” can set the temperature
value, set the range of 40-95°F.When the room temperature exceeds the set
temperature at 4°F,the machine stops working, and stay in the standby state.
When the temperature is lower than the set temperature, the machine starts to
heat up again.
Timing function
Timing stop
When the heater is turned on, press the TIMER key to enter the timing stop
state (within 0-8 hours), then press the “+” key to increase the timing stop
time , and press the “-” key to decrease the timing stop time.
Timing start
When the electric heater is in the standby mode, press the TIMER key to enter
the reservation start mode (within 0-8 hours), then press the “+” key to
increase the reservation start time , and press the “-” key to decrease the
reservation start time .
Oscillation function
The electric heater in operation mode, press the “Oscillation” key to open the
oscillation function, pressing this button to turn off the oscillation
function; when the electric heater stops heating function, the wind
oscillating function also stop.
Temperature sensor short circuit, open circuit protection function
No matter in what mode, the temperature sensor appears short circuit or
open circuit, digital screen displays “E1” or “E2” and constantly flicker,
while any key operation is invalid and the buzzer rings 10 times
Safety protection
In the start state, when the room temperature TH is above 122°F, close all
outputs system, The digital screen displays “FF” and flashes 1 time per second
at a frequency of 75 times, press any key will not work, only the power down
to exit the protection.
Tip-over switch
As a safety measure, the unit will shut off automatically if it is knocked
over. Should this occur, simply turn the heater off and stand it back up to a
regular upright posit ion, then switch it back on.
ECO energy saving function
Select the ECO energy saving gear and set the temperature. The heater will
adjust its heating gear by comparison between the ambient temperature and set
temperature.
Remote controller
Use of the remote controller: the key functions are basically the same as the
body operation panel.
Remote control
| ON/off button
---|---
| Mode button
| Temperature/ Timer increase
| Temperature/Timer increase
| Timer button
| Swing button
Do not mix old and new batteries and Do not mix alkaline, standard (carbon-
zinc) or rechargeable (ni-cad, ni-mh, etc.) batteries
MAIN TECHNOLOGY SPECIFICATIONS
Power supply: AC 120V ~ 60Hz
| MODEL | POWER REGULATION RANGE (W) |
|---|---|
| LOW | HIGH |
| PTHW15-18MR | 900 |
Troubleshooting
If the product does not operate or does not operate properly, first check according to the following list. If the reason the product does not operate or does not operate properly is not included in the following list, the product may have failed. At this time, it is recommended to send the product to the dealer for treatment.
| Problem | Possible Cause | Solution |
|---|---|---|
| A er the power is engaged,the machine does not work. | The plug may not be | |
| plugged well. | Check whether the plug is properly inserted into the |
receptacle.
The machine suddenly stops during heaving.| The temperature exceeds the
threshold of the thermal cut- o .| Unplug the heater and cool the machine
before use.
CLEANING AND STORAGE
It is recommended that the heater be cleaned at least one time during the operating season in order to provide the optimum level of performance. ALWAYS TURN THE POWER SWITCH OFF AND UNPLUG THE HEATER BEFORE CLEANING. Be sure to save the box for off season storage.
- Turn the heater “OFF”, unplug it and wait for the heater to cool down.
- Use a dry cloth to clean only external surfaces of the heater.
- Do not use any cleaning agents or detergents.
- Never immerse the heater in water.
- Pack the heater in the original carton and store it in a cool and dry place.
READ AND SAVE THESE INSTRUCTIONS
ONE (1) YEAR LIMITED WARRANTY
- Please read all instructions before attempting to use this product.
Midea America Corporation warrants as limited herein to the original purchaser of retail that each new Fan-forced heater, shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase. This one (1) year warranty is limited to the heating elements, motor, and electric control circuit board.
In the event of malfunctions or failure of your Pelonis Fan-forced heater, simply deliver or send the heater, postage prepaid along with PROOF OF PURCHASE, within the warranty period of one (1) year, to Midea America Corporation. Midea America Corporation reserves the right to inspect the claimed defective part or parts to determine if the defect or malfunction complaint is covered by this warranty. Midea America Corporation shall, within sixty (60) days after receipt of the product,at its option, repair and/or replace the defective part or parts free of charge. This warranty Shall only cover defects arising from normal usage. Midea America Corporation assumes no responsibility whatsoever if the Fan-forced heater should fail during the warranty period by reason of:
- Misuse, negligence, physical damage or accidents.
- Lack ofmaintenance (see instructions for proper maintenance).
- Repair by any unauthorized party during the warranty period.
- Damage caused by connection to an improper input voltage (see specification label on your heater).
Midea America Corporation makes no further warranties or representations,
express or implied except those contained herein. No representative or dealer
is authorized to assume any other liability regarding the Fan-forced heater.
The duration of the implied warranty granted under State law, including
warranties of merchant ability and fitness for particular purpose are limited
in duration should the duration of the express warranty grant it hereunder.
Midea America Corporation shall in no event be liable for direct, indirect,
special or consequential damages.
Some states do not allow limitations on how long an implied warranty lasts, and/or the above limitations or exclusion may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state.
Free 3 months extension* of the original limited warranty period! Simply text
a picture of your proof of purchase to:
1-844-224-1614
The warranty extension is for the three months immediately following the completion of the product’soriginal warranty period.
SERVICE & SUPPORT
In the event of warrant claim or if service is required for this heater, please contact us at the following:
Toll Free: 1-866-4332
For questions or comments,please write to:
Midea America Corp
5 Sylvan Way, Suite 100
Parsippany, NJ 07054
Phone: 866 646 4332
For your records, staple your sales receipt to this manual and record the following:
DATE OF PURCHASE:
PLACE OF PURCHASE:
(STAPLE SALES RECEIPT HERE)
NOTE:PROOF OF PURCHASE IS REQUIRED FOE ALL
WARRANTY CLAIMS
PRINTED IN CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>